On Sat, Sep 23, 2023 at 04:48:52PM +0300, Vladimir Oltean wrote:
> In Layerscape and QorIQ SoCs, compliance with the backplane Ethernet
> protocol is bolted on top of the SerDes lanes using an external IP core,
> that is modeled as an Ethernet PHY. This means that dynamic tuning of
> the electrical equalization parameters of the link needs to be
> communicated with the consumer of the generic PHY.
>
> Create a small layer of glue API between a networking PHY (dealing with
> the AN/LT logic for backplanes) and a generic PHY by extending the
> phy_configure() API with a new struct phy_configure_opts_ethernet.
>
> There are 2 directions of interest. In the "local TX training", the
> generic PHY consumer gets requests over the wire from the link partner
> regarding changes we should make to our TX equalization. In the "remote
> TX training" direction, the generic PHY is the producer of requests,
> based on its RX status, and the generic PHY consumer polls for these
> requests until we are happy. Each request is also sent (externally to
> the generic PHY layer) to the link partner board, for it to adjust its
> TX equalization.
>
> struct phy_configure_opts_ethernet is valid when phy_set_mode_ext() has
> been called with PHY_MODE_ETHERNET or PHY_MODE_ETHTOOL, same as with
> other union phy_configure_opts types.
>
> Signed-off-by: Vladimir Oltean <vladimir.oltean@xxxxxxx>
...
> +/**
> + * struct phy_configure_opts_ethernet - Ethernet PHY configuration set
nit: please include documentation of the structure members - type,
local_tx, and remote_tx - here.
> + *
> + * This structure is used to represent the configuration state of an Ethernet
> + * PHY (of various media types).
> + */
> +struct phy_configure_opts_ethernet {
> + enum ethernet_phy_configure_type type;
> + union {
> + struct c72_phy_configure_local_tx local_tx;
> + struct c72_phy_configure_remote_tx remote_tx;
> + };
> +};
...
