From: Vincent Knecht <vincent.knecht@xxxxxxxxxx> Enable sound and modem for the Alcatel Idol 3 (4.7"). The setup is similar to most MSM8916 devices, i.e.: - QDSP6 audio - Microphones via digital/analog codec in MSM8916/PM8916 - WWAN Internet via BAM-DMUX except: - Stereo NXP TFA9890 codecs for speakers on Quaternary MI2S - These are also used as earpieces at the top/bottom. - Asahi Kasei AK4375 headphone codec on Secondary MI2S -> Primary MI2S is not used for playback Signed-off-by: Vincent Knecht <vincent.knecht@xxxxxxxxxx> [Stephan: minor cleanup, add consistent commit message] Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx> --- There are some trivial conflicts unless https://lore.kernel.org/linux-arm-msm/20230921-msm8916-rmem-fixups-v1-3-34d2b6e721cf@xxxxxxxxxxx/ is applied first. But given that there are important fixups for the dynamic reserved memory changes in that series it should preferably get applied before this one anyway. --- .../boot/dts/qcom/msm8916-alcatel-idol347.dts | 164 +++++++++++++++++++++ 1 file changed, 164 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts b/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts index fade93c55299..ef5fc9289754 100644 --- a/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts +++ b/arch/arm64/boot/dts/qcom/msm8916-alcatel-idol347.dts @@ -3,6 +3,8 @@ /dts-v1/; #include "msm8916-pm8916.dtsi" +#include "msm8916-modem-qdsp6.dtsi" + #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/input/input.h> #include <dt-bindings/leds/common.h> @@ -22,6 +24,19 @@ chosen { stdout-path = "serial0"; }; + reserved-memory { + /delete-node/ reserved@86680000; + /delete-node/ rmtfs@86700000; + + rmtfs: rmtfs@86680000 { + compatible = "qcom,rmtfs-mem"; + reg = <0x0 0x86680000 0x0 0x160000>; + no-map; + + qcom,client-id = <1>; + }; + }; + gpio-keys { compatible = "gpio-keys"; @@ -50,6 +65,17 @@ led-0 { }; }; + reg_headphones_avdd: regulator-headphones-avdd { + compatible = "regulator-fixed"; + regulator-name = "headphones_avdd"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <1800000>; + gpio = <&tlmm 121 GPIO_ACTIVE_HIGH>; + enable-active-high; + pinctrl-0 = <&headphones_avdd_default>; + pinctrl-names = "default"; + }; + usb_id: usb-id { compatible = "linux,extcon-usb-gpio"; id-gpios = <&tlmm 69 GPIO_ACTIVE_HIGH>; @@ -58,6 +84,43 @@ usb_id: usb-id { }; }; +&blsp_i2c3 { + status = "okay"; + + headphones: audio-codec@10 { + compatible = "asahi-kasei,ak4375"; + reg = <0x10>; + avdd-supply = <®_headphones_avdd>; + tvdd-supply = <&pm8916_l6>; + pdn-gpios = <&tlmm 114 GPIO_ACTIVE_HIGH>; + pinctrl-0 = <&headphones_pdn_default>; + pinctrl-names = "default"; + #sound-dai-cells = <0>; + }; + + speaker_codec_top: audio-codec@34 { + compatible = "nxp,tfa9897"; + reg = <0x34>; + vddd-supply = <&pm8916_l6>; + rcv-gpios = <&tlmm 50 GPIO_ACTIVE_HIGH>; + pinctrl-0 = <&speaker_top_default>; + pinctrl-names = "default"; + sound-name-prefix = "Speaker Top"; + #sound-dai-cells = <0>; + }; + + speaker_codec_bottom: audio-codec@36 { + compatible = "nxp,tfa9897"; + reg = <0x36>; + vddd-supply = <&pm8916_l6>; + rcv-gpios = <&tlmm 111 GPIO_ACTIVE_HIGH>; + pinctrl-0 = <&speaker_bottom_default>; + pinctrl-names = "default"; + sound-name-prefix = "Speaker Bottom"; + #sound-dai-cells = <0>; + }; +}; + &blsp_i2c4 { status = "okay"; @@ -153,6 +216,18 @@ &blsp_uart2 { status = "okay"; }; +&mpss_mem { + reg = <0x0 0x86800000 0x0 0x5000000>; +}; + +&pm8916_codec { + qcom,micbias1-ext-cap; + qcom,micbias-lvl = <2800>; + qcom,mbhc-vthreshold-low = <75 100 120 180 500>; + qcom,mbhc-vthreshold-high = <75 100 120 180 500>; + qcom,hphl-jack-type-normally-open; +}; + &pm8916_resin { status = "okay"; linux,code = <KEY_VOLUMEDOWN>; @@ -169,6 +244,17 @@ &pm8916_vib { status = "okay"; }; +&q6afedai { + dai@18 { + reg = <SECONDARY_MI2S_RX>; + qcom,sd-lines = <0>; + }; + dai@22 { + reg = <QUATERNARY_MI2S_RX>; + qcom,sd-lines = <0>; + }; +}; + &sdhc_1 { status = "okay"; }; @@ -183,6 +269,47 @@ &sdhc_2 { cd-gpios = <&tlmm 38 GPIO_ACTIVE_LOW>; }; +&sound { + status = "okay"; + + /* Add pin switches for speakers to allow disabling them individually */ + model = "alcatel-idol3"; + widgets = + "Speaker", "Speaker Top", + "Speaker", "Speaker Bottom"; + pin-switches = "Speaker Top", "Speaker Bottom"; + audio-routing = + "Speaker Top", "Speaker Top OUT", + "Speaker Bottom", "Speaker Bottom OUT", + "AMIC1", "MIC BIAS External1", + "AMIC2", "MIC BIAS Internal2", + "AMIC3", "MIC BIAS External1"; + + pinctrl-0 = <&cdc_pdm_default &pri_mi2s_default &pri_mi2s_ws_default &sec_mi2s_default>; + pinctrl-1 = <&cdc_pdm_sleep &pri_mi2s_sleep &pri_mi2s_ws_sleep &sec_mi2s_sleep>; + pinctrl-names = "default", "sleep"; +}; + +&sound_dai_primary { + status = "disabled"; +}; + +&sound_dai_quaternary { + status = "okay"; + + codec { + sound-dai = <&speaker_codec_top>, <&speaker_codec_bottom>; + }; +}; + +&sound_dai_secondary { + status = "okay"; + + codec { + sound-dai = <&headphones>; + }; +}; + &usb { status = "okay"; extcon = <&usb_id>, <&usb_id>; @@ -212,6 +339,15 @@ &wcnss_mem { status = "okay"; }; +/* Only some of the pins are used */ +&pri_mi2s_default { + pins = "gpio113", "gpio115"; +}; + +&pri_mi2s_sleep { + pins = "gpio113", "gpio115"; +}; + &tlmm { accel_int_default: accel-int-default-state { pins = "gpio31"; @@ -245,6 +381,20 @@ gyro_int_default: gyro-int-default-state { bias-disable; }; + headphones_avdd_default: headphones-avdd-default-state { + pins = "gpio121"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + + headphones_pdn_default: headphones-pdn-default-state { + pins = "gpio114"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + /* * The OEM wired an additional GPIO to be asserted so that * the si-en,sn3190 LED IC works. Since this GPIO is not @@ -291,6 +441,20 @@ sdc2_cd_default: sdc2-cd-default-state { bias-disable; }; + speaker_bottom_default: speaker-bottom-default-state { + pins = "gpio111"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + + speaker_top_default: speaker-top-default-state { + pins = "gpio50"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + }; + ts_int_reset_default: ts-int-reset-default-state { pins = "gpio13", "gpio100"; function = "gpio"; -- 2.42.0
