Il 19/09/23 03:44, Mark Tseng ha scritto:
MT8188 svs gpu uses 2-line high bank and low bank to optimize the
voltage of opp table for higher and lower frequency respectively.
Signed-off-by: Mark Tseng <chun-jen.tseng@xxxxxxxxxxxx>
---
drivers/soc/mediatek/mtk-svs.c | 184 ++++++++++++++++++++++++++++++++-
1 file changed, 180 insertions(+), 4 deletions(-)
diff --git a/drivers/soc/mediatek/mtk-svs.c b/drivers/soc/mediatek/mtk-svs.c
index 3a2f97cd5272..f31e3bedff50 100644
--- a/drivers/soc/mediatek/mtk-svs.c
+++ b/drivers/soc/mediatek/mtk-svs.c
@@ -407,6 +407,7 @@ struct svs_platform_data {
* @dcbdet: svs efuse data
* @dcmdet: svs efuse data
* @turn_pt: 2-line turn point tells which opp_volt calculated by high/low bank
+ * @vbin_turn_pt: voltage bin turn point helps know which svsb_volt should be overridden
* @type: bank type to represent it is 2-line (high/low) bank or 1-line bank
*
* Svs bank will generate suitalbe voltages by below general math equation
@@ -469,6 +470,7 @@ struct svs_bank {
u32 dcbdet;
u32 dcmdet;
u32 turn_pt;
+ u32 vbin_turn_pt;
u32 type;
};
@@ -751,11 +753,12 @@ static int svs_status_debug_show(struct seq_file *m, void *v)
ret = thermal_zone_get_temp(svsb->tzd, &tzone_temp);
if (ret)
- seq_printf(m, "%s: temperature ignore, turn_pt = %u\n",
- svsb->name, svsb->turn_pt);
+ seq_printf(m, "%s: temperature ignore, vbin_turn_pt = %u, turn_pt = %u\n",
+ svsb->name, svsb->vbin_turn_pt, svsb->turn_pt);
else
- seq_printf(m, "%s: temperature = %d, turn_pt = %u\n",
- svsb->name, tzone_temp, svsb->turn_pt);
+ seq_printf(m, "%s: temperature = %d, vbin_turn_pt = %u, turn_pt = %u\n",
+ svsb->name, tzone_temp, svsb->vbin_turn_pt,
+ svsb->turn_pt);
for (i = 0; i < svsb->opp_count; i++) {
opp = dev_pm_opp_find_freq_exact(svsb->opp_dev,
@@ -952,6 +955,29 @@ static void svs_get_bank_volts_v3(struct svs_platform *svsp)
for (i = opp_start; i < opp_stop; i++)
if (svsb->volt_flags & SVSB_REMOVE_DVTFIXED_VOLT)
svsb->volt[i] -= svsb->dvt_fixed;
+
+ /* For voltage bin support */
I already asked you to please send the voltage bin support as a separated commit
because this is for *all SoCs* and not only for 8188.
Again, please separate the voltage bin support from the MT8188 support.
soc: mediatek: svs: Add support for voltage bins
soc: mediatek: svs: Add support for MT8188 SoC
Regards,
Angelo
