On Fri, 15 Sep 2023 17:10:16 -0700, Wesley Cheng wrote: > Add a dt-binding to describe the definition of enabling the Q6 USB backend > device for audio offloading. The node carries information, which is passed > along to the QC USB SND class driver counterpart. These parameters will be > utilized during QMI stream enable requests. > > Signed-off-by: Wesley Cheng <quic_wcheng@xxxxxxxxxxx> > --- > .../devicetree/bindings/sound/qcom,q6usb.yaml | 55 +++++++++++++++++++ > 1 file changed, 55 insertions(+) > create mode 100644 Documentation/devicetree/bindings/sound/qcom,q6usb.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/sound/qcom,q6usb.yaml: $id: Cannot determine base path from $id, relative path/filename doesn't match actual path or filename $id: http://devicetree.org/schemas/sound/qcom,q6usb-dais.yaml file: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/sound/qcom,q6usb.yaml /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/sound/qcom,q6usb.example.dtb: dais: qcom,usb-audio-intr-num:0: [0, 2] is too long from schema $id: http://devicetree.org/schemas/sound/qcom,q6usb-dais.yaml# /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/sound/qcom,q6usb.example.dtb: dais: qcom,usb-audio-intr-num:0: [0, 2] is too long from schema $id: http://devicetree.org/schemas/sound/qcom,q6usb-dais.yaml# doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230916001026.315-24-quic_wcheng@xxxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
