Add GPIO hogging documentation to gpio.txt
Signed-off-by: Benoit Parrot <bparrot@xxxxxx>
Reviewed-by: Alexandre Courbot <acourbot@xxxxxxxxxx>
---
Documentation/devicetree/bindings/gpio/gpio.txt | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/Documentation/devicetree/bindings/gpio/gpio.txt b/Documentation/devicetree/bindings/gpio/gpio.txt
index b9bd1d6..f5d2717 100644
--- a/Documentation/devicetree/bindings/gpio/gpio.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio.txt
@@ -115,6 +115,22 @@ Every GPIO controller node must contain both an empty "gpio-controller"
property, and a #gpio-cells integer property, which indicates the number of
cells in a gpio-specifier.
+The GPIO chip may contain GPIO hog definitions. GPIO hogging is a mechanism
+providing automatic GPIO request and configuration as part of the
+gpio-controller's driver probe function.
+
+Each GPIO hog definition is represented as a child node of the GPIO controller.
+Required properties:
+- gpio-hog: A property specifying that this child node represent a GPIO hog.
+- gpios: Store the GPIO information (id, flags, ...). Shall contain the
+ number of cells specified in its parent node (GPIO controller
+ node).
+- state: A property specifying the direction/value needed. This property
+ can take the following values: input, output-high, output-low.
+
+Optional properties:
+- line-name: The GPIO label name. If not present the node name is used.
+
Example of two SOC GPIO banks defined as gpio-controller nodes:
qe_pio_a: gpio-controller@1400 {
@@ -122,6 +138,13 @@ Example of two SOC GPIO banks defined as gpio-controller nodes:
reg = <0x1400 0x18>;
gpio-controller;
#gpio-cells = <2>;
+
+ line_b {
+ gpio-hog;
+ gpios = <6 0>;
+ state = "output-low";
+ line-name = "foo-bar-gpio";
+ };
};
qe_pio_e: gpio-controller@1460 {
--
1.8.5.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
