Exynos 4210 supports setting a base threshold value, which is added to all trip points. This might be useful, but is not really necessary in our usecase, so we always set it to 0 to simplify the code a bit. Additionally, this change makes it so that we convert the value to the calibrated one in a slightly different place. This is more correct morally, though it does not make any change when single-point calibration is being used (which is the case currently). Signed-off-by: Mateusz Majewski <m.majewski2@xxxxxxxxxxx> --- drivers/thermal/samsung/exynos_tmu.c | 17 +++-------------- 1 file changed, 3 insertions(+), 14 deletions(-) diff --git a/drivers/thermal/samsung/exynos_tmu.c b/drivers/thermal/samsung/exynos_tmu.c index 5da44f43715d..6c107fe9fd27 100644 --- a/drivers/thermal/samsung/exynos_tmu.c +++ b/drivers/thermal/samsung/exynos_tmu.c @@ -336,20 +336,7 @@ static void exynos_tmu_control(struct platform_device *pdev, bool on) static void exynos4210_tmu_set_trip_temp(struct exynos_tmu_data *data, int trip_id, u8 temp) { - struct thermal_trip trip; - u8 ref, th_code; - - if (thermal_zone_get_trip(data->tzd, 0, &trip)) - return; - - ref = trip.temperature / MCELSIUS; - - if (trip_id == 0) { - th_code = temp_to_code(data, ref); - writeb(th_code, data->base + EXYNOS4210_TMU_REG_THRESHOLD_TEMP); - } - - temp -= ref; + temp = temp_to_code(data, temp); writeb(temp, data->base + EXYNOS4210_TMU_REG_TRIG_LEVEL0 + trip_id * 4); } @@ -364,6 +351,8 @@ static void exynos4210_tmu_initialize(struct platform_device *pdev) struct exynos_tmu_data *data = platform_get_drvdata(pdev); sanitize_temp_error(data, readl(data->base + EXYNOS_TMU_REG_TRIMINFO)); + + writeb(0, data->base + EXYNOS4210_TMU_REG_THRESHOLD_TEMP); } static void exynos4412_tmu_set_trip_temp(struct exynos_tmu_data *data, -- 2.41.0