On 07/08/2023 15:37, Linus Walleij wrote:
On Mon, Jul 24, 2023 at 8:02 AM Huqiang Qin <huqiang.qin@xxxxxxxxxxx> wrote:
After adding this binding header file, you can intuitively find
the interrupt number corresponding to each GPIO, and apply it
in the format of IRQID_XXX where it needs to be used.
(...)
Huqiang Qin (3):
dt-bindings: interrupt-controller: Add header file for Amlogic
Meson-G12A SoCs
pinctrl: Replace the IRQ number in the driver with the IRQID macro
definition
arm64: dts: Replace the IRQ number with the IRQID macro definition
Neil wrote:
What's the best way to apply this patchset ?
I just applied all three to the pin control tree.
I could have applied just the two first and then offered an
immutable branch. But eh... too much work for too low risk.
Better to just apply it and hope all works out. If it explodes
I just back out and figure something like the above.
Perfect, thx :-)
Neil
Yours,
Linus Walleij
