From: Marius Cristea <marius.cristea@xxxxxxxxxxxxx> This is the device tree schema for iio driver for Microchip family of 153.6 ksps, Low-Noise 16/24-Bit Delta-Sigma ADCs with an SPI interface (Microchip's MCP3461, MCP3462, MCP3464, MCP3461R, MCP3462R, MCP3464R, MCP3561, MCP3562, MCP3564, MCP3561R, MCP3562R and MCP3564R analog to digital converters). Signed-off-by: Marius Cristea <marius.cristea@xxxxxxxxxxxxx> --- .../bindings/iio/adc/microchip,mcp3564.yaml | 200 ++++++++++++++++++ 1 file changed, 200 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/adc/microchip,mcp3564.yaml diff --git a/Documentation/devicetree/bindings/iio/adc/microchip,mcp3564.yaml b/Documentation/devicetree/bindings/iio/adc/microchip,mcp3564.yaml new file mode 100644 index 000000000000..4a264f48a90e --- /dev/null +++ b/Documentation/devicetree/bindings/iio/adc/microchip,mcp3564.yaml @@ -0,0 +1,200 @@ +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/iio/adc/microchip,mcp3564.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Microchip MCP346X and MCP356X ADC Family + +maintainers: + - Marius Cristea <marius.cristea@xxxxxxxxxxxxx> + +description: | + Bindings for the Microchip family of 153.6 ksps, Low-Noise 16/24-Bit + Delta-Sigma ADCs with an SPI interface. Datasheet can be found here: + Datasheet for MCP3561, MCP3562, MCP3564 can be found here: + https://ww1.microchip.com/downloads/aemDocuments/documents/MSLD/ProductDocuments/DataSheets/MCP3561-2-4-Family-Data-Sheet-DS20006181C.pdf + Datasheet for MCP3561R, MCP3562R, MCP3564R can be found here: + https://ww1.microchip.com/downloads/aemDocuments/documents/APID/ProductDocuments/DataSheets/MCP3561_2_4R-Data-Sheet-DS200006391C.pdf + Datasheet for MCP3461, MCP3462, MCP3464 can be found here: + https://ww1.microchip.com/downloads/aemDocuments/documents/APID/ProductDocuments/DataSheets/MCP3461-2-4-Two-Four-Eight-Channel-153.6-ksps-Low-Noise-16-Bit-Delta-Sigma-ADC-Data-Sheet-20006180D.pdf + Datasheet for MCP3461R, MCP3462R, MCP3464R can be found here: + https://ww1.microchip.com/downloads/aemDocuments/documents/APID/ProductDocuments/DataSheets/MCP3461-2-4R-Family-Data-Sheet-DS20006404C.pdf + +properties: + compatible: + enum: + - microchip,mcp3461 + - microchip,mcp3462 + - microchip,mcp3464 + - microchip,mcp3461r + - microchip,mcp3462r + - microchip,mcp3464r + - microchip,mcp3561 + - microchip,mcp3562 + - microchip,mcp3564 + - microchip,mcp3561r + - microchip,mcp3562r + - microchip,mcp3564r + + reg: + maxItems: 1 + + spi-max-frequency: + maximum: 20000000 + + spi-cpha: true + + spi-cpol: true + + vdd-supply: true + + avdd-supply: true + + clocks: + description: + Phandle and clock identifier for external sampling clock. + If not specified, the internal crystal oscillator will be used. + maxItems: 1 + + interrupts: + description: IRQ line of the ADC + maxItems: 1 + + drive-open-drain: + description: + Whether to drive the IRQ signal as push-pull (default) or open-drain. Note + that the device requires this pin to become "high", otherwise it will stop + converting. + type: boolean + + vref-supply: + description: + Some devices have a specific reference voltage supplied on a different + pin to the other supplies. Needed to be able to establish channel scaling + unless there is also an internal reference available (e.g. mcp3564r). In + case of "r" devices (e. g. mcp3564r), if it does not exists the internal + reference will be used. + + microchip,hw-device-address: + $ref: /schemas/types.yaml#/definitions/uint32 + minimum: 0 + maximum: 3 + description: + The address is set on a per-device basis by fuses in the factory, + configured on request. If not requested, the fuses are set for 0x1. + The device address is part of the device markings to avoid + potential confusion. This address is coded on two bits, so four possible + addresses are available when multiple devices are present on the same + SPI bus with only one Chip Select line for all devices. + Each device communication starts by a CS falling edge, followed by the + clocking of the device address (BITS[7:6] - top two bits of COMMAND BYTE + which is first one on the wire). + + "#io-channel-cells": + const: 1 + + "#address-cells": + const: 1 + + "#size-cells": + const: 0 + +patternProperties: + "^channel@([0-9]|([1-7][0-9]))$": + $ref: adc.yaml + type: object + unevaluatedProperties: false + description: Represents the external channels which are connected to the ADC. + + properties: + reg: + description: The channel number in single-ended and differential mode. + minimum: 0 + maximum: 79 + + required: + - reg + +dependencies: + spi-cpol: [ spi-cpha ] + spi-cpha: [ spi-cpol ] + +required: + - compatible + - reg + - microchip,hw-device-address + - spi-max-frequency + +allOf: + - $ref: /schemas/spi/spi-peripheral-props.yaml# + - # External vref, no internal reference + if: + properties: + compatible: + contains: + enum: + - microchip,mcp3461 + - microchip,mcp3462 + - microchip,mcp3464 + - microchip,mcp3561 + - microchip,mcp3562 + - microchip,mcp3564 + then: + required: + - vref-supply + +unevaluatedProperties: false + +examples: + - | + spi { + #address-cells = <1>; + #size-cells = <0>; + + adc@0 { + compatible = "microchip,mcp3564r"; + reg = <0>; + vref-supply = <&vref_reg>; + spi-cpha; + spi-cpol; + spi-max-frequency = <10000000>; + microchip,hw-device-address = <1>; + + #address-cells = <1>; + #size-cells = <0>; + + channel@0 { + /* CH0 to AGND */ + reg = <0>; + }; + + channel@1 { + /* CH1 to AGND */ + reg = <1>; + }; + + /* diff-channels */ + channel@11 { + reg = <11>; + + /* CN0, CN1 */ + diff-channels = <0 1>; + }; + + channel@22 { + reg = <0x22>; + + /* CN1, CN2 */ + diff-channels = <1 2>; + }; + + channel@23 { + reg = <0x23>; + + /* CN1, CN3 */ + diff-channels = <1 3>; + }; + }; + }; +... -- 2.34.1
