Hi Esteban,
>This patch adds support for TPS6594 PMIC family on wakup I2C0 bus.
>Theses devices provides regulators (bucks and LDOs), but also
>GPIOs, a RTC, a watchdog, an ESM (Error Signal Monitor)
>which monitors the SoC error output signal, and a PFSM
>(Pre-configurable Finite State Machine) which manages the
>operational modes of the PMIC.
>
>Signed-off-by: Esteban Blanc <eblanc@xxxxxxxxxxxx>
>---
> arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 157 ++++++++++++++++++++
> 1 file changed, 157 insertions(+)
>
>diff --git a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>index b37f4f88ece4..e45d97cc41a5 100644
>--- a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>+++ b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
>@@ -127,6 +127,14 @@ J721E_WKUP_IOPAD(0x9c, PIN_INPUT_PULLUP, 0) /*
>(H21) WKUP_I2C0_SDA */
> };
> };
>
>+&wkup_pmx3 {
>+ pmic_irq_pins_default: pmic-irq-pins-default {
>+ pinctrl-single,pins = <
>+ J721E_WKUP_IOPAD(0x1c, PIN_INPUT, 7) /* (E18)
>WKUP_GPIO0_84 */
Could you use 0x01c format instead of 0x1c,
and similar format in other patches in this series too.
Rest LGTM
>+ >;
>+ };
>+};
>+
[..]
