Hi, This adds panel support for Inanbo T28CP45TN89, which I found inside of a handheld thermal camera. The panel is based on the st7789v controller. All information is based on reverse engineering. I also appended the series from Miquel Raynal adding EDT ET028013DMA panel support, so that I could easily test it with my SPI_NO_RX setup. They are slightly different due to rebasing. Changes since PATCHv2: * https://lore.kernel.org/all/20230422205012.2464933-1-sre@xxxxxxxxxx/ * https://lore.kernel.org/all/20230616163255.2804163-1-miquel.raynal@xxxxxxxxxxx/ * Add Rob Herring's R-b for the DT binding * Make panel info "static const" * Add Michael Riesch's R-b to all my patches * Rebase to 6.5-rc1 * Append Miquel's series Changes since PATCHv1: * https://lore.kernel.org/all/20230317232355.1554980-1-sre@xxxxxxxxxx/ * Apply DT binding changes requested by Krzysztof Kozlowski and his Ack * I changed the driver patches to avoid code duplication and splitted the code a bit more Greetings, -- Sebastian Miquel Raynal (6): dt-bindings: display: st7789v: Add the edt,et028013dma panel compatible dt-bindings: display: st7789v: bound the number of Rx data lines drm/panel: sitronix-st7789v: Use 9 bits per spi word by default drm/panel: sitronix-st7789v: Clarify a definition drm/panel: sitronix-st7789v: Add EDT ET028013DMA panel support drm/panel: sitronix-st7789v: Check display ID Sebastian Reichel (13): dt-bindings: vendor-prefixes: add Inanbo dt-bindings: display: st7789v: add Inanbo T28CP45TN89 drm/panel: sitronix-st7789v: add SPI ID table drm/panel: sitronix-st7789v: remove unused constants drm/panel: sitronix-st7789v: make reset GPIO optional drm/panel: sitronix-st7789v: simplify st7789v_spi_write drm/panel: sitronix-st7789v: improve error handling drm/panel: sitronix-st7789v: avoid hardcoding mode info drm/panel: sitronix-st7789v: avoid hardcoding panel size drm/panel: sitronix-st7789v: add media bus format drm/panel: sitronix-st7789v: avoid hardcoding invert mode drm/panel: sitronix-st7789v: avoid hardcoding polarity info drm/panel: sitronix-st7789v: add Inanbo T28CP45TN89 support .../display/panel/sitronix,st7789v.yaml | 10 +- .../devicetree/bindings/vendor-prefixes.yaml | 2 + .../gpu/drm/panel/panel-sitronix-st7789v.c | 262 +++++++++++++++--- 3 files changed, 237 insertions(+), 37 deletions(-) -- 2.40.1
