On 12/07/2023 15:04, Krzysztof Kozlowski wrote:
On 12/07/2023 13:38, Varadarajan Narayanan wrote:Add USB phy and controller nodes. Signed-off-by: Varadarajan Narayanan <quic_varada@xxxxxxxxxxx> --- v4: Change node name Remove blank line 'make CHECK_DTBS=y DT_SCHEMA_FILES=qcom qcom/ipq5332-rdp441.dtb' passed v1: Rename phy node Change compatible from m31,ipq5332-usb-hsphy -> qcom,ipq5332-usb-hsphy Remove 'qscratch' from phy node Fix alignment and upper-case hex no.s Add clock definition for the phy Remove snps,ref-clock-period-ns as it is not used. dwc3_ref_clk_period() in dwc3/core.c takes the frequency from ref clock and calculates fladj as appropriate. --- arch/arm64/boot/dts/qcom/ipq5332.dtsi | 53 +++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/ipq5332.dtsi b/arch/arm64/boot/dts/qcom/ipq5332.dtsi index 8bfc2db..8118356 100644 --- a/arch/arm64/boot/dts/qcom/ipq5332.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq5332.dtsi @@ -405,6 +405,59 @@ status = "disabled"; }; }; + + usbphy0: usb-phy@7b000 { + compatible = "qcom,ipq5332-usb-hsphy"; + reg = <0x0007b000 0x12c>; + + clocks = <&gcc GCC_USB0_PHY_CFG_AHB_CLK>; + clock-names = "cfg_ahb"; + + resets = <&gcc GCC_QUSB2_0_PHY_BCR>; + + status = "disabled"; + }; + + usb2: usb2@8a00000 {So you responded to my comments, wait ten minutes and send v2? No need to wait for my feedback, right? No, it's not ok. This is "usb", not "usb2". Are you saying you have second device with the same address?
Just to emphasise, it's the node name `usb2', which is not fine. DT label `usb2' is (hopefully) fine.
-- With best wishes Dmitry
