On 05/07/2023 08:48, Krzysztof Kozlowski wrote:
> GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
> These are simple defines so they could be used in DTS but they will not
> have the same meaning: GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE.
>
> Correct the interrupt flags, assuming the author of the code wanted same
> logical behavior behind the name "ACTIVE_xxx", this is:
> ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW
This should be HIGH in both cases. I will send a v2.
>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts b/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> index d1f343345f67..6464ef4d113d 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> @@ -773,7 +773,7 @@ brcmf: wifi@1 {
> compatible = "brcm,bcm4329-fmac";
> reg = <1>;
> interrupt-parent = <&gpio0>;
> - interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
> + interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
Best regards,
Krzysztof
