On 12/08/2014 02:22 PM, Arnd Bergmann wrote:
On Monday 08 December 2014 12:53:30 Lee Jones wrote:
This is a new driver which controls the SPI component of ST's
Synchronous Serial Controller (SSC).
How does this related to the i2c driver for drivers/i2c/busses/i2c-st.c?
Could you have the same piece of hardware do one or the other mode
depending on pin configuration, or is each instance hardwired to
a particular mode?
This is the same IP, that can be configured either in SPI or I2C.
Is there any code worth sharing between the two drivers?
No, except a couple of registers, they are managed in a ways.
The way it is used, a single SSC instance can only be used either in SPI
or I2C mode on a board,
so I think it wouldn't make sense to create a MFD driver to manage it.
Kr,
Maxime
Arnd
_______________________________________________
Kernel mailing list
Kernel@xxxxxxxxxxx
http://www.stlinux.com/mailman/listinfo/kernel
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
