GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning: GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE.
Correct the interrupt flags, assuming the author of the code wanted same
logical behavior behind the name "ACTIVE_xxx", this is:
ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts b/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
index cec3b7b1b947..8a17c1eaae15 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
@@ -31,7 +31,7 @@ brcmf: wifi@1 {
compatible = "brcm,bcm4329-fmac";
reg = <1>;
interrupt-parent = <&gpio0>;
- interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
+ interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "host-wake";
pinctrl-names = "default";
pinctrl-0 = <&wifi_host_wake_l>;
--
2.34.1
