Re: [PATCH v3 1/2] dt-bindings: leds: Read max-brightness from devicetree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 03/07/2023 15:03, Astrid Rost wrote:
> Normally, the maximum brightness is determined by the hardware, and this
> property is not required. This property is used to set a software limit.
> It could happen that an LED is made so bright that it gets damaged or
> causes damage due to restrictions in a specific system, such as mounting
> conditions.
> Note that this flag is mainly used for PWM-LEDs, where it is not possible
> to map brightness to current. Drivers for other controllers should use
> led-max-microamp.
> 
> Signed-off-by: Astrid Rost <astrid.rost@xxxxxxxx>

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

Best regards,
Krzysztof




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux