On Mon, Jun 12, 2023 at 11:53:51AM +0200, AngeloGioacchino Del Regno wrote: > Il 12/06/23 09:02, Hans Verkuil ha scritto: > > Hi Nicolas, > > > > On 07/06/2023 22:53, Nícolas F. R. A. Prado wrote: > > > > > > This series enables the hardware decoder present on mt8183. At first > > > glance, the only missing piece is the devicetree node for it, however, > > > simply adding it as is would cause an address collision between the > > > first register iospace and the clock-controller node, so a rework of the > > > dt-binding and driver, as well as addition of a clock, were needed > > > first. > > > > > > Tested that H264 decoding works with the hardware decoder on > > > mt8183-kukui-jacuzzi-juniper-sku16, giving a fluster score of 98/135 on > > > the JVT-AVC_V1 test suite. And ensured other SoCs (MT8192 and MT8195) > > > still work as usual. > > > > > > Changes in v2: > > > - Merged commit 1 (media: dt-bindings: mediatek,vcodec: Allow single > > > clock for mt8183) into commit 3 (media: dt-bindings: mediatek,vcodec: > > > Remove VDEC_SYS for mt8183) > > > - Further constrained properties in dt-binding > > > - Added CLK_IGNORE_UNUSED flag to active clock > > > - Reformatted reg-names in DT node > > > > > > Nícolas F. R. A. Prado (4): > > > media: dt-bindings: mediatek,vcodec: Don't require assigned-clocks > > > media: dt-bindings: mediatek,vcodec: Remove VDEC_SYS for mt8183 > > > media: mediatek: vcodec: Read HW active status from clock > > > clk: mediatek: mt8183: Add CLK_VDEC_ACTIVE to vdec > > > > Is the clk patch independent from the others? It's not clear to me. > > > > If the clk patch has to go in together with the media patches, then > > please let me know and post a v3 where the clk patch is also CC-ed to > > the linux-media mailinglist to ensure it ends up in our patchwork system. > > > > And in that case I need a Acked-by from the clk maintainer as well. > > > > If it is independent, then there is no need for a v3 (at least, not > > for this). > > > > The clock patch is not independent, as in the devicetree changes will not > work without the addition of that clock (and of course even fail building), Yes, but that means that the devicetree patch is dependent of the clock patch, but the clock patch is independent from the media patches, and can therefore be applied through the clock tree as usual. So, the media patches (first three) can be merged through the media tree, the clock patch (patch 4) through the clock tree independently, and the only requirement is that the DT patch (last one) is only applied by Matthias after the clock patch is present, to avoid build problems, and also after the media patches are present, to avoid dt-binding errors. Thanks, Nícolas
