Re: [PATCH 6/7] drm/panel: sitronix-st7789v: Add EDT ET028013DMA panel support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jun 09, 2023 at 04:59:50PM +0200, Miquel Raynal wrote:
> This panel from Emerging Display Technologies Corporation features an
> ST7789V2 panel inside which is almost identical to what the Sitronix
> panel driver supports.
> 
> In practice, the module physical size is specific, and experiments show
> that the display will malfunction if any of the following situation
> occurs:
> * Pixel clock is above 3MHz
> * Pixel clock is not inverted
> I could not properly identify the reasons behind these failures, scope
> captures show valid input signals.

The patch includes an additional change where the bus_flags are assigned
to the connector. At least tell why, or maybe split it out.
Other panels could learn to do the same - and I assume you did it
because it was required in the atmel_hlcd driver.

	Sam

> 
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
> ---
>  .../gpu/drm/panel/panel-sitronix-st7789v.c    | 34 +++++++++++++++++--
>  1 file changed, 32 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> index 212bccc31804..7de192a3a8aa 100644
> --- a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> +++ b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
> @@ -30,7 +30,8 @@
>  #define ST7789V_RGBCTRL_RCM(n)			(((n) & 3) << 5)
>  #define ST7789V_RGBCTRL_VSYNC_HIGH		BIT(3)
>  #define ST7789V_RGBCTRL_HSYNC_HIGH		BIT(2)
> -#define ST7789V_RGBCTRL_PCLK_HIGH		BIT(1)
> +#define ST7789V_RGBCTRL_PCLK_FALLING		BIT(1)
> +#define ST7789V_RGBCTRL_PCLK_RISING		0
>  #define ST7789V_RGBCTRL_VBP(n)			((n) & 0x7f)
>  #define ST7789V_RGBCTRL_HBP(n)			((n) & 0x1f)
>  
> @@ -117,6 +118,7 @@ struct st7789v_panel_info {
>  	u16 width_mm;
>  	u16 height_mm;
>  	u32 bus_format;
> +	u32 bus_flags;
>  };
>  
>  struct st7789v {
> @@ -175,6 +177,18 @@ static const struct drm_display_mode default_mode = {
>  	.vtotal = 320 + 8 + 4 + 4,
>  };
>  
> +static const struct drm_display_mode slow_mode = {
> +	.clock = 3000,
> +	.hdisplay = 240,
> +	.hsync_start = 240 + 38,
> +	.hsync_end = 240 + 38 + 10,
> +	.htotal = 240 + 38 + 10 + 10,
> +	.vdisplay = 320,
> +	.vsync_start = 320 + 8,
> +	.vsync_end = 320 + 8 + 4,
> +	.vtotal = 320 + 8 + 4 + 4,
> +};
> +
>  static int st7789v_get_modes(struct drm_panel *panel,
>  			     struct drm_connector *connector)
>  {
> @@ -197,6 +211,7 @@ static int st7789v_get_modes(struct drm_panel *panel,
>  
>  	connector->display_info.width_mm = panel_info->width_mm;
>  	connector->display_info.height_mm = panel_info->height_mm;
> +	connector->display_info.bus_flags = panel_info->bus_flags;
>  	drm_display_info_set_bus_formats(&connector->display_info,
>  					 &panel_info->bus_format, 1);
>  
> @@ -206,8 +221,13 @@ static int st7789v_get_modes(struct drm_panel *panel,
>  static int st7789v_prepare(struct drm_panel *panel)
>  {
>  	struct st7789v *ctx = panel_to_st7789v(panel);
> +	const struct st7789v_panel_info *panel_info = ctx->panel_info;
> +	u8 pck = ST7789V_RGBCTRL_PCLK_FALLING;
>  	int ret;
>  
> +	if (panel_info->bus_flags & DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE)
> +		pck = ST7789V_RGBCTRL_PCLK_RISING;
> +
>  	ret = regulator_enable(ctx->power);
>  	if (ret)
>  		return ret;
> @@ -321,7 +341,7 @@ static int st7789v_prepare(struct drm_panel *panel)
>  					     ST7789V_RGBCTRL_RCM(2) |
>  					     ST7789V_RGBCTRL_VSYNC_HIGH |
>  					     ST7789V_RGBCTRL_HSYNC_HIGH |
> -					     ST7789V_RGBCTRL_PCLK_HIGH));
> +					     pck));
>  	ST7789V_TEST(ret, st7789v_write_data(ctx, ST7789V_RGBCTRL_VBP(8)));
>  	ST7789V_TEST(ret, st7789v_write_data(ctx, ST7789V_RGBCTRL_HBP(20)));
>  
> @@ -422,14 +442,24 @@ static const struct st7789v_panel_info st7789v_info = {
>  	.bus_format = MEDIA_BUS_FMT_RGB666_1X18,
>  };
>  
> +static const struct st7789v_panel_info et028013dma_info = {
> +	.display_mode = &slow_mode,
> +	.width_mm = 43,
> +	.height_mm = 58,
> +	.bus_format = MEDIA_BUS_FMT_RGB666_1X18,
> +	.bus_flags = DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE,
> +};
> +
>  static const struct of_device_id st7789v_of_match[] = {
>  	{ .compatible = "sitronix,st7789v", .data = &st7789v_info },
> +	{ .compatible = "edt,et028013dma", .data = &et028013dma_info },
>  	{ }
>  };
>  MODULE_DEVICE_TABLE(of, st7789v_of_match);
>  
>  static const struct spi_device_id st7789v_ids[] = {
>  	{ "st7789v", },
> +	{ "et028013dma", },
>  	{ /* sentinel */ }
>  };
>  MODULE_DEVICE_TABLE(spi, st7789v_ids);
> -- 
> 2.34.1



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux