On 28/05/2023 02:10, Rudraksha Gupta wrote:
> Add the required nodes to support USB on the MSM8960 SoC. As it's very
> similar to the APQ8064 SoC, the nodes are almost identical
>
> Add a label to sleep_clk for the USB node to reference
>
> Signed-off-by: Rudraksha Gupta <guptarud@xxxxxxxxx>
> + usb1: usb@12500000 {
> + compatible = "qcom,ci-hdrc";
> + reg = <0x12500000 0x200>,
> + <0x12500200 0x200>;
> + interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&gcc USB_HS1_XCVR_CLK>, <&gcc USB_HS1_H_CLK>;
> + clock-names = "core", "iface";
> + assigned-clocks = <&gcc USB_HS1_XCVR_CLK>;
> + assigned-clock-rates = <60000000>;
> + resets = <&gcc USB_HS1_RESET>;
> + reset-names = "core";
> + phy_type = "ulpi";
> + ahb-burst-config = <0>;
> + phys = <&usb_hs1_phy>;
> + phy-names = "usb-phy";
> + status = "disabled";
status is the last
> + #reset-cells = <1>;
> +
> + ulpi {
> + usb_hs1_phy: phy {
> + compatible = "qcom,usb-hs-phy-msm8960",
> + "qcom,usb-hs-phy";
> + clocks = <&sleep_clk>, <&cxo_board>;
> + clock-names = "sleep", "ref";
> + resets = <&usb1 0>;
> + reset-names = "por";
> + #phy-cells = <0>;
> + };
> + };
> + };
> +
Don't add stray blank lines.
Best regards,
Krzysztof
