在 2023/5/16 22:35, Sudeep Holla 写道:
On Tue, May 16, 2023 at 10:13:58PM +0800, lihuisong (C) wrote:
[...]
But I still need the device-flags to report if use PCC operation Region.
If so I have to dig one address register from comm subspace, right?
[...]
Thanks for you bringing it up.
Indeed, this HCCS_DEV_FLAGS_INTR_B is not good.
I'm going to replace it with PCC operation Region flag.
>From the above 2, I am getting a sense that all these flags dance is for
sharing a PCC subspace ID between this driver and the firmware PCC Opregion ?
No. I want to use this flag to make compability between different platforms.
This driver only use PCC OpRegion to access to the channel if platform
support use PCC OpRegion.
Driver must select one of them (PCC and PCC OpRegion) to communicate
with firmware on one platform.
If so that may not work as the current implementation of PCC Opregion
assumes the exclusive access to the channel. Since it is initialised
quite early, Opregion must succeed to get the mbox channel acquired and
this driver must fail if they are sharing the channel. Making the sharing
across firmware and this driver may need changes in the PCC Opregion
Only using PCC OpRegion after requesting and releasing PCC channel
shouldn't change PCC OpRegion code?
support code. One possible way is to acquire and release the channel for
each transaction which will be definitely overhead.
Yes, transaction will be definitely overhead.
The following method should be no such problem.
-->
If driver want to obtain other info by RegisterAddress and offset in PCC
Register(),
driver generally needs to do it as follows:
1> get channel ID and RegisterAddress and offset.
2> call pcc_mbox_request_channel to acquire the channel.
3> ioremap 'shmem_base_addr' to get 'pcc_comm_addr'
4> obtain other info based on RegisterAddress, offset and 'pcc_comm_addr'.
If driver selects PCC OpRegion method, driver may also need to release
this PCC channel by calling pcc_mbox_free_channel.
Because this channel will be requested when PCC OpRegion method is
executed for the first time.
Overall, the above process is a bit cumbersome if this driver only use
PCC OpRegion.
In addition, I have to dig one address from comm space in share memory,
which will cause the available size of comm space to decrease, right?
So it is better to use other way to do get channel ID and other info if
it is possible.
What do you think?
