On 04/05/2023 09:32, Johannes Zink wrote: > Hi Rob, hi Krzysztof, > > [snip] > > gentle ping - any opinions on this? Shall I just send a V2 along the > lines of the phy-stm32-usbphy.c? > > This would be something like (example for the trim-hs-current, taken > from pyh-stm32-usbphyc): > > st,trim-hs-current: > description: | > Controls HS driver current trimming for choke compensation > - <0> = 18.87 mA target current / nominal + 0% > - <1> = 19.165 mA target current / nominal + 1.56% > - <2> = 19.46 mA target current / nominal + 3.12% > - <3> = 19.755 mA target current / nominal + 4.68% > - <4> = 20.05 mA target current / nominal + 6.24% > - <5> = 20.345 mA target current / nominal + 7.8% > - <6> = 20.64 mA target current / nominal + 9.36% > - <7> = 20.935 mA target current / nominal + 10.92% > - <8> = 21.23 mA target current / nominal + 12.48% > - <9> = 21.525 mA target current / nominal + 14.04% > - <10> = 21.82 mA target current / nominal + 15.6% > - <11> = 22.115 mA target current / nominal + 17.16% > - <12> = 22.458 mA target current / nominal + 19.01% > - <13> = 22.755 mA target current / nominal + 20.58% > - <14> = 23.052 mA target current / nominal + 22.16% > - <15> = 23.348 mA target current / nominal + 23.73% > $ref: /schemas/types.yaml#/definitions/uint32 > minimum: 0 > maximum: 15 > default: 0 > > If you think something along these lines is acceptable, I would like to > prepare and send a V2. > Go with Rob's approach, so something as you wrote above. Best regards, Krzysztof
