The SPI-NOR node in the device tree of the BananaPi R64 has most likely
been copied from the reference board's device tree even though the R64
comes with an SPI-NAND chip rather than SPI-NOR.
Setup the Serial NAND Flash Interface (SNFI) controller, enable
hardware BCH error detection and correction engine and add the SPI-NAND
chip including basic partitions,
Signed-off-by: Daniel Golle <daniel@xxxxxxxxxxxxxx>
---
.../dts/mediatek/mt7622-bananapi-bpi-r64.dts | 39 ++++++++++++++++---
1 file changed, 34 insertions(+), 5 deletions(-)
diff --git a/arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dts b/arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dts
index af3fe61e40938..d583e816684cf 100644
--- a/arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dts
+++ b/arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dts
@@ -248,14 +248,42 @@ &nandc {
status = "disabled";
};
-&nor_flash {
- pinctrl-names = "default";
- pinctrl-0 = <&spi_nor_pins>;
- status = "disabled";
+&bch {
+ status = "okay";
+};
+&snfi {
+ pinctrl-names = "default";
+ pinctrl-0 = <&serial_nand_pins>;
+ status = "okay";
flash@0 {
- compatible = "jedec,spi-nor";
+ compatible = "spi-nand";
reg = <0>;
+ spi-tx-bus-width = <4>;
+ spi-rx-bus-width = <4>;
+ nand-ecc-engine = <&snfi>;
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ label = "bl2";
+ reg = <0x0 0x80000>;
+ read-only;
+ };
+
+ partition@80000 {
+ label = "fip";
+ reg = <0x80000 0x200000>;
+ read-only;
+ };
+
+ ubi: partition@280000 {
+ label = "ubi";
+ reg = <0x280000 0x7d80000>;
+ };
+ };
};
};
base-commit: 13961ef828cbc254cc272221b7fc54851caa39a7
--
2.40.0
