Re: [PATCH v5 14/14] phy: qcom-qmp: Register as a typec switch for orientation detection

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Apr 13, 2023 at 12:34:38PM +0100, Bryan O'Donoghue wrote:
> From: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> 
> The lane select switch for USB typec orientation is within the USB QMP PHY.
> the current device.  It could be connected through an endpoint, to an
> independent device handling the typec detection, ie the QCOM SPMI typec
> driver.
> 
> bod: Fixed the logic qcom_qmp_phy_typec_switch_set() to disable phy
>  on disconnect if and only if we have initialized the PHY.
>  Retained CC orientation logic in qcom_qmp_phy_com_init() to simplify
>  patch.
> 
> bod: Ported from earlier version of driver to phy-qcom-qmp-combo.c
> 
> Co-developed-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
> Signed-off-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
> Co-developed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

Your s-o-b should be last here...

> ---
>  drivers/phy/qualcomm/Kconfig              |  8 +++
>  drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 80 +++++++++++++++++++++--
>  2 files changed, 84 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/phy/qualcomm/Kconfig b/drivers/phy/qualcomm/Kconfig
> index 4850d48f31fa1..8240fffdbed4e 100644
> --- a/drivers/phy/qualcomm/Kconfig
> +++ b/drivers/phy/qualcomm/Kconfig
> @@ -101,6 +101,14 @@ config PHY_QCOM_QMP_USB
>  
>  endif # PHY_QCOM_QMP
>  
> +config PHY_QCOM_QMP_TYPEC
> +	def_bool PHY_QCOM_QMP=y && TYPEC=y || PHY_QCOM_QMP=m && TYPEC
> +	help
> +	  Register a type C switch from the QMP PHY driver for type C
> +	  orientation support.  This has dependencies with if the type C kernel
> +	  configuration is enabled or not.  This support will not be present if
> +	  USB type C is disabled.
> +
>  config PHY_QCOM_QUSB2
>  	tristate "Qualcomm QUSB2 PHY Driver"
>  	depends on OF && (ARCH_QCOM || COMPILE_TEST)
> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
> index 6850e04c329b8..b9a30c087423d 100644
> --- a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
> +++ b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
> @@ -19,6 +19,7 @@
>  #include <linux/regulator/consumer.h>
>  #include <linux/reset.h>
>  #include <linux/slab.h>
> +#include <linux/usb/typec_mux.h>
>  
>  #include <dt-bindings/phy/phy-qcom-qmp.h>
>  
> @@ -63,6 +64,10 @@
>  /* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */
>  #define CLAMP_EN				BIT(0) /* enables i/o clamp_n */
>  
> +/* QPHY_V3_DP_COM_TYPEC_CTRL register bits */
> +#define SW_PORTSELECT_VAL			BIT(0)
> +#define SW_PORTSELECT_MUX			BIT(1)
> +
>  #define PHY_INIT_COMPLETE_TIMEOUT		10000
>  
>  struct qmp_phy_init_tbl {
> @@ -1323,6 +1328,9 @@ struct qmp_combo {
>  	struct clk_fixed_rate pipe_clk_fixed;
>  	struct clk_hw dp_link_hw;
>  	struct clk_hw dp_pixel_hw;
> +
> +	struct typec_switch_dev *sw;
> +	enum typec_orientation orientation;
>  };
>  
>  static void qmp_v3_dp_aux_init(struct qmp_combo *qmp);
> @@ -1955,7 +1963,8 @@ static void qmp_v3_configure_dp_tx(struct qmp_combo *qmp)
>  static bool qmp_combo_configure_dp_mode(struct qmp_combo *qmp)
>  {
>  	u32 val;
> -	bool reverse = false;
> +	bool reverse = qmp->orientation == TYPEC_ORIENTATION_REVERSE;
> +	const struct phy_configure_opts_dp *dp_opts = &qmp->dp_opts;
>  
>  	val = DP_PHY_PD_CTL_PWRDN | DP_PHY_PD_CTL_AUX_PWRDN |
>  	      DP_PHY_PD_CTL_PLL_PWRDN | DP_PHY_PD_CTL_DP_CLAMP_EN;
> @@ -1974,10 +1983,18 @@ static bool qmp_combo_configure_dp_mode(struct qmp_combo *qmp)
>  	 * if (orientation == ORIENTATION_CC2)
>  	 *	writel(0x4c, qmp->dp_dp_phy + QSERDES_V3_DP_PHY_MODE);
>  	 */
> +	if (dp_opts->lanes == 4 || reverse)
> +		val |= DP_PHY_PD_CTL_LANE_0_1_PWRDN;
> +	if (dp_opts->lanes == 4 || !reverse)
> +		val |= DP_PHY_PD_CTL_LANE_2_3_PWRDN;
> +
>  	val |= DP_PHY_PD_CTL_LANE_2_3_PWRDN;

When "reverse" this implies 4 lanes, I think it's an accidental left
over from introducing the conditionals.

>  	writel(val, qmp->dp_dp_phy + QSERDES_DP_PHY_PD_CTL);
>  
> -	writel(0x5c, qmp->dp_dp_phy + QSERDES_DP_PHY_MODE);
> +	if (reverse)
> +		writel(0x4c, qmp->pcs + QSERDES_DP_PHY_MODE);
> +	else
> +		writel(0x5c, qmp->pcs + QSERDES_DP_PHY_MODE);
>  
>  	return reverse;
>  }
> @@ -2461,6 +2478,7 @@ static int qmp_combo_com_init(struct qmp_combo *qmp)
>  {
>  	const struct qmp_phy_cfg *cfg = qmp->cfg;
>  	void __iomem *com = qmp->com;
> +	u32 val;
>  	int ret;
>  
>  	mutex_lock(&qmp->phy_mutex);
> @@ -2498,8 +2516,11 @@ static int qmp_combo_com_init(struct qmp_combo *qmp)
>  			SW_DPPHY_RESET_MUX | SW_DPPHY_RESET |
>  			SW_USB3PHY_RESET_MUX | SW_USB3PHY_RESET);
>  
> -	/* Default type-c orientation, i.e CC1 */
> -	qphy_setbits(com, QPHY_V3_DP_COM_TYPEC_CTRL, 0x02);
> +	/* Latch CC orientation based on reported state by TCPM */
> +	val = SW_PORTSELECT_MUX;
> +	if (qmp->orientation == TYPEC_ORIENTATION_REVERSE)
> +		val |= SW_PORTSELECT_VAL;
> +	qphy_setbits(com, QPHY_V3_DP_COM_TYPEC_CTRL, val);
>  
>  	qphy_setbits(com, QPHY_V3_DP_COM_PHY_MODE_CTRL, USB3_MODE | DP_MODE);
>  
> @@ -3338,6 +3359,53 @@ static struct phy *qmp_combo_phy_xlate(struct device *dev, struct of_phandle_arg
>  	return ERR_PTR(-EINVAL);
>  }
>  
> +#if IS_ENABLED(CONFIG_PHY_QCOM_QMP_TYPEC)
> +static int qmp_combo_typec_switch_set(struct typec_switch_dev *sw,
> +				      enum typec_orientation orientation)
> +{
> +	struct qmp_combo *qmp = typec_switch_get_drvdata(sw);
> +	struct phy *dp_phy = qmp->dp_phy;
> +	int ret = 0;
> +
> +	dev_dbg(qmp->dev, "Toggling orientation current %d requested %d\n",
> +		qmp->orientation, orientation);
> +
> +	qmp->orientation = orientation;
> +
> +	if (orientation == TYPEC_ORIENTATION_NONE) {
> +		if (qmp->init_count)
> +			ret = qmp_combo_dp_power_off(dp_phy);
> +	} else {
> +		if (!qmp->init_count)
> +			ret = qmp_combo_dp_power_on(dp_phy);
> +	}

This sequence is crashing my laptop, need some more time to debug the
actual cause.

Regards,
Bjorn

> +
> +	return 0;
> +}
> +
> +static int qmp_combo_typec_switch_register(struct qmp_combo *qmp)
> +{
> +	struct typec_switch_desc sw_desc;
> +	struct device *dev = qmp->dev;
> +
> +	sw_desc.drvdata = qmp;
> +	sw_desc.fwnode = dev->fwnode;
> +	sw_desc.set = qmp_combo_typec_switch_set;
> +	qmp->sw = typec_switch_register(dev, &sw_desc);
> +	if (IS_ERR(qmp->sw)) {
> +		dev_err(dev, "Error registering typec switch: %ld\n",
> +			PTR_ERR(qmp->sw));
> +	}
> +
> +	return 0;
> +}
> +#else
> +static int qmp_combo_typec_switch_register(struct qmp_combo *qmp)
> +{
> +	return 0;
> +}
> +#endif
> +
>  static int qmp_combo_probe(struct platform_device *pdev)
>  {
>  	struct qmp_combo *qmp;
> @@ -3428,6 +3496,10 @@ static int qmp_combo_probe(struct platform_device *pdev)
>  	else
>  		phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
>  
> +	ret = qmp_combo_typec_switch_register(qmp);
> +	if (ret)
> +		goto err_node_put;
> +
>  	of_node_put(usb_np);
>  	of_node_put(dp_np);
>  
> -- 
> 2.39.2
> 



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux