On 4/14/23 13:27, Krzysztof Kozlowski wrote:
> On 14/04/2023 11:34, Cristian Ciocaltea wrote:
>> The RK8602 and RK8603 voltage regulators on the Rock 5B board provide
>> the power lines vdd_cpu_big0 and vdd_cpu_big1, respectively.
>>
>> Add the necessary device tree nodes and bind them to the corresponding
>> CPU big core nodes.
>>
>> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx>
>> ---
>> .../boot/dts/rockchip/rk3588-rock-5b.dts | 56 +++++++++++++++++++
>> 1 file changed, 56 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>> index 8cc97d146a73..3e4aee8f70c1 100644
>> --- a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>> +++ b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>> @@ -53,6 +53,62 @@ vcc5v0_sys: vcc5v0-sys-regulator {
>> };
>> };
>>
>> +&cpu_b0 {
>> + cpu-supply = <&vdd_cpu_big0_s0>;
>> +};
>> +
>> +&cpu_b1 {
>> + cpu-supply = <&vdd_cpu_big0_s0>;
>> +};
>> +
>> +&cpu_b2 {
>> + cpu-supply = <&vdd_cpu_big1_s0>;
>> +};
>> +
>> +&cpu_b3 {
>> + cpu-supply = <&vdd_cpu_big1_s0>;
>> +};
>> +
>> +&i2c0 {
>> + pinctrl-names = "default";
>> + pinctrl-0 = <&i2c0m2_xfer>;
>> + status = "okay";
>> +
>> + vdd_cpu_big0_s0: regulator@42 {
>> + compatible = "rockchip,rk8602";
>
> Looking at your next node, this is surprising... Double check if you
> have correct compatibles everywhere.
>
>> + reg = <0x42>;
>> + fcs,suspend-voltage-selector = <1>;
>
> Does not look like you tested the DTS against bindings. Please run `make
> dtbs_check` (see Documentation/devicetree/bindings/writing-schema.rst
> for instructions).
>
>> + regulator-name = "vdd_cpu_big0_s0";
>> + regulator-always-on;
>> + regulator-boot-on;
>> + regulator-min-microvolt = <550000>;
>> + regulator-max-microvolt = <1050000>;
>> + regulator-ramp-delay = <2300>;
>> + vin-supply = <&vcc5v0_sys>;
>> +
>> + regulator-state-mem {
>> + regulator-off-in-suspend;
>> + };
>> + };
>> +
>> + vdd_cpu_big1_s0: regulator@43 {
>> + compatible = "rockchip,rk8603", "rockchip,rk8602";
>> + reg = <0x43>;
>> + fcs,suspend-voltage-selector = <1>;
>
> Does not look like you tested the DTS against bindings. Please run `make
> dtbs_check` (see Documentation/devicetree/bindings/writing-schema.rst
> for instructions).
I mentioned in the cover letter that the support for the RK860X
regulators has been recently merged via [1]. The patches in this
series have been verified on next-20230413.
[1] https://lore.kernel.org/lkml/20230406194158.963352-1-cristian.ciocaltea@xxxxxxxxxxxxx/
Thanks,
Cristian
