Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers. Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sc8280xp.dtsi | 4 ----
1 file changed, 4 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
index 4c75da1bac2d..5632c3b8e416 100644
--- a/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc8280xp.dtsi
@@ -2728,7 +2728,6 @@ data-pins {
pins = "gpio7";
function = "dmic1_data";
drive-strength = <8>;
- input-enable;
};
};
@@ -2746,7 +2745,6 @@ data-pins {
function = "dmic1_data";
drive-strength = <2>;
bias-pull-down;
- input-enable;
};
};
@@ -2762,7 +2760,6 @@ data-pins {
pins = "gpio9";
function = "dmic2_data";
drive-strength = <8>;
- input-enable;
};
};
@@ -2780,7 +2777,6 @@ data-pins {
function = "dmic2_data";
drive-strength = <2>;
bias-pull-down;
- input-enable;
};
};
--
2.34.1
