Hi Jim,
Am 06.04.23 um 14:46 schrieb Jim Quinlan:
Regarding "brcm,enable-l1ss":
The Broadcom STB/CM PCIe HW -- which is also used by RPi SOCs -- requires
the driver probe to configure one of three clkreq# modes:
(a) clkreq# driven by the RC
(b) clkreq# driven by the EP for ASPM L0s, L1
(c) bidirectional clkreq#, as used for L1 Substates (L1SS).
The HW can tell the difference between (a) and (b), but does not know
when to configure (c). Further, the HW will cause a CPU abort on boot if
guesses wrong regarding the need for (c). So we introduce the boolean
"brcm,enable-l1ss" property to indicate that (c) is desired. This
property is already present in the Raspian version of Linux, but the
driver implementaion that will follow adds more details and discerns
between (a) and (b).
Regarding "brcm,completion-timeout-msecs"
Our HW will cause a CPU abort if the L1SS exit time is longer than the
completion abort timeout. We've been asked to make this configurable, so
we are introducing "brcm,completion-abort-msecs".
Signed-off-by: Jim Quinlan <jim2101024@xxxxxxxxx>
---
.../devicetree/bindings/pci/brcm,stb-pcie.yaml | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml b/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
index 7e15aae7d69e..ef4ccc05b258 100644
--- a/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
+++ b/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
@@ -64,6 +64,18 @@ properties:
aspm-no-l0s: true
+ brcm,enable-l1ss:
+ description: Indicates that the downstream device is L1SS
+ capable and L1SS is desired, e.g. by setting
+ CONFIG_PCIEASPM_POWER_SUPERSAVE=y. Note that CLKREQ#
not sure about this, but maybe we should avoid references to Linux
kernel config parameter in a DT binding. Since the driver already gaves
warning in case the DT parameter is present, but kernel config doesn't
fit, this should be enough.
+ assertion to clock active must be within 400ns.
+ type: boolean
+
+ brcm,completion-timeout-msecs:
+ description: Number of msecs before completion timeout
+ abort occurs.
+ $ref: /schemas/types.yaml#/definitions/uint32
According to the driver at least 0 is not allowed, maybe we should
define minimum and maximum here and let dtbs_check take care of invalid
values?
Best regards
+
brcm,scb-sizes:
description: u64 giving the 64bit PCIe memory
viewport size of a memory controller. There may be up to
