On Thu, 06 Apr 2023 13:54:04 +0200, Konrad Dybcio wrote: > Convert the ATH10K bindings to YAML. > > Dropped properties that are absent at the current state of mainline: > - qcom,msi_addr > - qcom,msi_base > > qcom,coexist-support and qcom,coexist-gpio-pin do very little and should > be reconsidered on the driver side, especially the latter one. > > Somewhat based on the ath11k bindings. > > Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> > --- > .../bindings/net/wireless/qcom,ath10k.txt | 215 ------------ > .../bindings/net/wireless/qcom,ath10k.yaml | 359 +++++++++++++++++++++ > 2 files changed, 359 insertions(+), 215 deletions(-) > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi@18800000: wifi-firmware: 'wifi-firmware' does not match any of the regexes: 'pinctrl-[0-9]+' From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi@18800000: wifi-firmware: 'iommus' is a required property From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml doc reference errors (make refcheckdocs): MAINTAINERS: Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230406-topic-ath10k_bindings-v2-1-557f884a65d1@xxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
