The platform can use several instances of PM8350C PMIC. Allow overriding
the SID and node labels inside pm8350c.dtsi.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/pm8350c.dtsi | 27 ++++++++++++++++++++-------
1 file changed, 20 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
index ee25c07ce31d..ddfc8fd6bb3e 100644
--- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -6,12 +6,23 @@
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
+/* (Sadly) this PMIC can be configured to be at different SIDs */
+#ifndef PMIC_SID
+ #define PMIC_SID 2
+#endif
+
+#ifndef PMIC_LABEL
+ #define PMIC_LABEL pm8350c
+#endif
+
+#include "pmic-dyn-header.dtsi"
+
/ {
thermal-zones {
pm8350c-thermal {
polling-delay-passive = <100>;
polling-delay = <0>;
- thermal-sensors = <&pm8350c_temp_alarm>;
+ thermal-sensors = <&LABEL(temp_alarm)>;
trips {
trip0 {
@@ -31,33 +42,35 @@ pm8350c-crit {
};
&spmi_bus {
- pm8350c: pmic@2 {
+ pmic@PMIC_SID {
compatible = "qcom,pm8350c", "qcom,spmi-pmic";
- reg = <0x2 SPMI_USID>;
+ reg = <PMIC_SID SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
- pm8350c_temp_alarm: temp-alarm@a00 {
+ LABEL(temp_alarm): temp-alarm@a00 {
compatible = "qcom,spmi-temp-alarm";
reg = <0xa00>;
interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
#thermal-sensor-cells = <0>;
};
- pm8350c_gpios: gpio@8800 {
+ LABEL(gpios): gpio@8800 {
compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
reg = <0x8800>;
gpio-controller;
- gpio-ranges = <&pm8350c_gpios 0 0 9>;
+ gpio-ranges = <&LABEL(gpios) 0 0 9>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
- pm8350c_pwm: pwm {
+ LABEL(pwm): pwm {
compatible = "qcom,pm8350c-pwm";
#pwm-cells = <2>;
status = "disabled";
};
};
};
+
+#include "pmic-dyn-footer.dtsi"
--
2.30.2
