On 26.03.2023 11:16, Krzysztof Kozlowski wrote: > The soc node is supposed to have only device nodes with MMIO addresses, > so move the DSI OPP out of it (it is used also by second DSI1 on > SDM660): > > sda660-inforce-ifc6560.dtb: soc: opp-table-dsi: {'compatible': ['operating-points-v2'], ... should not be valid under {'type': 'object'} > From schema: dtschema/schemas/simple-bus.yaml > > Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> > > --- Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> Konrad > > Changes since v1: > 1. Move the node out of soc. Don't add Konrad's review tag. > --- > arch/arm64/boot/dts/qcom/sdm630.dtsi | 38 ++++++++++++++-------------- > 1 file changed, 19 insertions(+), 19 deletions(-) > > diff --git a/arch/arm64/boot/dts/qcom/sdm630.dtsi b/arch/arm64/boot/dts/qcom/sdm630.dtsi > index 72d9a12b5e9c..b91e423a3cfc 100644 > --- a/arch/arm64/boot/dts/qcom/sdm630.dtsi > +++ b/arch/arm64/boot/dts/qcom/sdm630.dtsi > @@ -328,6 +328,25 @@ memory@80000000 { > reg = <0x0 0x80000000 0x0 0x0>; > }; > > + dsi_opp_table: opp-table-dsi { > + compatible = "operating-points-v2"; > + > + opp-131250000 { > + opp-hz = /bits/ 64 <131250000>; > + required-opps = <&rpmpd_opp_svs>; > + }; > + > + opp-210000000 { > + opp-hz = /bits/ 64 <210000000>; > + required-opps = <&rpmpd_opp_svs_plus>; > + }; > + > + opp-262500000 { > + opp-hz = /bits/ 64 <262500000>; > + required-opps = <&rpmpd_opp_nom>; > + }; > + }; > + > pmu { > compatible = "arm,armv8-pmuv3"; > interrupts = <GIC_PPI 6 IRQ_TYPE_LEVEL_HIGH>; > @@ -1450,25 +1469,6 @@ mmcc: clock-controller@c8c0000 { > <0>; > }; > > - dsi_opp_table: opp-table-dsi { > - compatible = "operating-points-v2"; > - > - opp-131250000 { > - opp-hz = /bits/ 64 <131250000>; > - required-opps = <&rpmpd_opp_svs>; > - }; > - > - opp-210000000 { > - opp-hz = /bits/ 64 <210000000>; > - required-opps = <&rpmpd_opp_svs_plus>; > - }; > - > - opp-262500000 { > - opp-hz = /bits/ 64 <262500000>; > - required-opps = <&rpmpd_opp_nom>; > - }; > - }; > - > mdss: display-subsystem@c900000 { > compatible = "qcom,mdss"; > reg = <0x0c900000 0x1000>,