On Mon, Mar 20, 2023 at 11:55:48AM +0100, Johan Hovold wrote: > On Mon, Mar 20, 2023 at 11:50:30AM +0100, Konrad Dybcio wrote: > > > > > > On 20.03.2023 11:46, Johan Hovold wrote: > > > Describe the bus topology for PCIe domain 6 and add the ath11k > > > calibration variant so that the board file (calibration data) can be > > > loaded. > > > > > > Link: https://bugzilla.kernel.org/show_bug.cgi?id=216036 > > > Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx> > > > --- > > > arch/arm64/boot/dts/qcom/sc8280xp-crd.dts | 17 +++++++++++++++++ > > > 1 file changed, 17 insertions(+) > > > > > > diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts b/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts > > > index 90a5df9c7a24..5dfda12f669b 100644 > > > --- a/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts > > > > > > Was mixing > > > +++ b/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts > > > > this /\ > > > > [...] > > > > and this \/ > > > + qcom,ath11k-calibration-variant = "LE_X13S"; > > Intentional? Especially given Kalle's comment on bugzilla? > > Yes, it is intentional. The corresponding calibration data allows the > wifi to be used on the CRD. I measure 150 MBits/s which may a bit lower > than expected, but it's better than having no wifi at all. I was going back and forth about mentioning this in the commit message and we could off on this one until someone confirms that the corresponding calibration data can (or should) be used for the X13s. Note that there is no other match for 'bus=pci,vendor=17cb,device=1103,subsystem-vendor=17cb,subsystem-device=0108,qmi-chip-id=2,qmi-board-id=140' in the new board-2.bin. Johan
