On 14/03/2023 12:17, Fabio Estevam wrote:
Sometimes a GPIO is needed to turn on/off the display.
Add support for this usecase by introducing the optional 'enable-gpios'
property.
Tested on a imx53qsb board.
Signed-off-by: Fabio Estevam <festevam@xxxxxxx>
---
drivers/gpu/drm/panel/panel-seiko-43wvf1g.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/gpu/drm/panel/panel-seiko-43wvf1g.c b/drivers/gpu/drm/panel/panel-seiko-43wvf1g.c
index 76160e5d43bd..c250ca36a5b3 100644
--- a/drivers/gpu/drm/panel/panel-seiko-43wvf1g.c
+++ b/drivers/gpu/drm/panel/panel-seiko-43wvf1g.c
@@ -7,6 +7,7 @@
*/
#include <linux/delay.h>
+#include <linux/gpio/consumer.h>
#include <linux/media-bus-format.h>
#include <linux/module.h>
#include <linux/of.h>
@@ -48,6 +49,7 @@ struct seiko_panel {
const struct seiko_panel_desc *desc;
struct regulator *dvdd;
struct regulator *avdd;
+ struct gpio_desc *enable_gpio;
};
static inline struct seiko_panel *to_seiko_panel(struct drm_panel *panel)
@@ -139,6 +141,8 @@ static int seiko_panel_unprepare(struct drm_panel *panel)
if (!p->prepared)
return 0;
+ gpiod_set_value_cansleep(p->enable_gpio, 0);
+
regulator_disable(p->avdd);
/* Add a 100ms delay as per the panel datasheet */
@@ -174,6 +178,8 @@ static int seiko_panel_prepare(struct drm_panel *panel)
goto disable_dvdd;
}
+ gpiod_set_value_cansleep(p->enable_gpio, 1);
+
p->prepared = true;
return 0;
@@ -252,6 +258,12 @@ static int seiko_panel_probe(struct device *dev,
if (IS_ERR(panel->avdd))
return PTR_ERR(panel->avdd);
+ panel->enable_gpio = devm_gpiod_get_optional(dev, "enable",
+ GPIOD_OUT_LOW);
+ if (IS_ERR(panel->enable_gpio))
+ return dev_err_probe(dev, PTR_ERR(panel->enable_gpio),
+ "failed to request GPIO\n");
+
drm_panel_init(&panel->base, dev, &seiko_panel_funcs,
DRM_MODE_CONNECTOR_DPI);
Reviewed-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
