Sorting the registers and their bit definitions will make it easier to add
more definitions in the future and it also helps in maintenance.
While at it, let's also group the registers and bit definitions separately
as done in the pcie-qcom-ep driver.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
drivers/pci/controller/dwc/pcie-qcom.c | 108 ++++++++++++++-----------
1 file changed, 63 insertions(+), 45 deletions(-)
diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 6930bc9ceeb5..9223ca76640d 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -33,7 +33,36 @@
#include "../../pci.h"
#include "pcie-designware.h"
+/* PARF registers */
#define PARF_SYS_CTRL 0x00
+#define PARF_PM_CTRL 0x20
+#define PARF_PCS_DEEMPH 0x34
+#define PARF_PCS_SWING 0x38
+#define PARF_PHY_CTRL 0x40
+#define PARF_PHY_REFCLK 0x4C
+#define PARF_CONFIG_BITS 0x50
+#define PARF_DBI_BASE_ADDR 0x168
+#define PARF_SLV_ADDR_SPACE_SIZE_2_3_3 0x16C /* Register offset specific to IP ver 2.3.3 */
+#define PARF_MHI_CLOCK_RESET_CTRL 0x174
+#define PARF_AXI_MSTR_WR_ADDR_HALT 0x178
+#define PARF_AXI_MSTR_WR_ADDR_HALT_V2 0x1A8
+#define PARF_Q2A_FLUSH 0x1AC
+#define PARF_LTSSM 0x1B0
+#define PARF_SID_OFFSET 0x234
+#define PARF_BDF_TRANSLATE_CFG 0x24C
+#define PARF_SLV_ADDR_SPACE_SIZE 0x358
+#define PARF_DEVICE_TYPE 0x1000
+#define PARF_BDF_TO_SID_TABLE_N 0x2000
+
+/* ELBI registers */
+#define ELBI_SYS_CTRL 0x04
+
+/* DBI registers */
+#define AXI_MSTR_RESP_COMP_CTRL0 0x818
+#define AXI_MSTR_RESP_COMP_CTRL1 0x81c
+#define MISC_CONTROL_1_REG 0x8BC
+
+/* PARF_SYS_CTRL register fields */
#define MST_WAKEUP_EN BIT(13)
#define SLV_WAKEUP_EN BIT(12)
#define MSTR_ACLK_CGC_DIS BIT(10)
@@ -43,45 +72,56 @@
#define L23_CLK_RMV_DIS BIT(2)
#define L1_CLK_RMV_DIS BIT(1)
-#define PARF_PM_CTRL 0x20
+/* PARF_PM_CTRL register fields */
#define REQ_NOT_ENTR_L1 BIT(5)
-#define PARF_PHY_CTRL 0x40
+/* PARF_PCS_DEEMPH register fields */
+#define PCS_DEEMPH_TX_DEEMPH_GEN1(x) ((x) << 16)
+#define PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(x) ((x) << 8)
+#define PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(x) ((x) << 0)
+
+/* PARF_PCS_SWING register fields */
+#define PCS_SWING_TX_SWING_FULL(x) ((x) << 8)
+#define PCS_SWING_TX_SWING_LOW(x) ((x) << 0)
+
+/* PARF_PHY_CTRL register fields */
#define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK GENMASK(20, 16)
#define PHY_CTRL_PHY_TX0_TERM_OFFSET(x) ((x) << 16)
-#define PARF_PHY_REFCLK 0x4C
+/* PARF_PHY_REFCLK register fields */
#define PHY_REFCLK_SSP_EN BIT(16)
#define PHY_REFCLK_USE_PAD BIT(12)
-#define PARF_DBI_BASE_ADDR 0x168
-#define PARF_SLV_ADDR_SPACE_SIZE_2_3_3 0x16C /* Register offset specific to IP rev 2.3.3 */
-#define PARF_MHI_CLOCK_RESET_CTRL 0x174
+/* PARF_CONFIG_BITS register fields */
+#define PHY_RX0_EQ(x) ((x) << 24)
+
+/* PARF_SLV_ADDR_SPACE_SIZE register value */
+#define SLV_ADDR_SPACE_SZ 0x10000000
+
+/* PARF_MHI_CLOCK_RESET_CTRL register fields */
#define AHB_CLK_EN BIT(0)
#define MSTR_AXI_CLK_EN BIT(1)
#define BYPASS BIT(4)
-#define PARF_AXI_MSTR_WR_ADDR_HALT 0x178
-#define PARF_AXI_MSTR_WR_ADDR_HALT_V2 0x1A8
-#define PARF_LTSSM 0x1B0
-#define PARF_SID_OFFSET 0x234
-#define PARF_BDF_TRANSLATE_CFG 0x24C
-#define PARF_DEVICE_TYPE 0x1000
-#define PARF_BDF_TO_SID_TABLE_N 0x2000
+/* PARF_DEVICE_TYPE register fields */
+#define DEVICE_TYPE_RC 0x4
-#define ELBI_SYS_CTRL 0x04
+/* ELBI_SYS_CTRL register fields */
#define ELBI_SYS_CTRL_LT_ENABLE BIT(0)
-#define AXI_MSTR_RESP_COMP_CTRL0 0x818
+/* AXI_MSTR_RESP_COMP_CTRL0 register fields */
#define CFG_REMOTE_RD_REQ_BRIDGE_SIZE_2K 0x4
#define CFG_REMOTE_RD_REQ_BRIDGE_SIZE_4K 0x5
-#define AXI_MSTR_RESP_COMP_CTRL1 0x81c
+
+/* AXI_MSTR_RESP_COMP_CTRL1 register fields */
#define CFG_BRIDGE_SB_INIT BIT(0)
-#define PCIE_CAP_SLOT_POWER_LIMIT_VAL FIELD_PREP(PCI_EXP_SLTCAP_SPLV, \
- 250)
-#define PCIE_CAP_SLOT_POWER_LIMIT_SCALE FIELD_PREP(PCI_EXP_SLTCAP_SPLS, \
- 1)
+/* MISC_CONTROL_1_REG register fields */
+#define DBI_RO_WR_EN 1
+
+/* PCI_EXP_SLTCAP register fields */
+#define PCIE_CAP_SLOT_POWER_LIMIT_VAL FIELD_PREP(PCI_EXP_SLTCAP_SPLV, 250)
+#define PCIE_CAP_SLOT_POWER_LIMIT_SCALE FIELD_PREP(PCI_EXP_SLTCAP_SPLS, 1)
#define PCIE_CAP_SLOT_VAL (PCI_EXP_SLTCAP_ABP | \
PCI_EXP_SLTCAP_PCP | \
PCI_EXP_SLTCAP_MRLSP | \
@@ -93,34 +133,12 @@
PCIE_CAP_SLOT_POWER_LIMIT_VAL | \
PCIE_CAP_SLOT_POWER_LIMIT_SCALE)
-#define PARF_Q2A_FLUSH 0x1AC
-
-#define MISC_CONTROL_1_REG 0x8BC
-#define DBI_RO_WR_EN 1
-
#define PERST_DELAY_US 1000
-/* PARF registers */
-#define PARF_PCS_DEEMPH 0x34
-#define PCS_DEEMPH_TX_DEEMPH_GEN1(x) ((x) << 16)
-#define PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(x) ((x) << 8)
-#define PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(x) ((x) << 0)
-
-#define PARF_PCS_SWING 0x38
-#define PCS_SWING_TX_SWING_FULL(x) ((x) << 8)
-#define PCS_SWING_TX_SWING_LOW(x) ((x) << 0)
-
-#define PARF_CONFIG_BITS 0x50
-#define PHY_RX0_EQ(x) ((x) << 24)
-
-#define PARF_SLV_ADDR_SPACE_SIZE 0x358
-#define SLV_ADDR_SPACE_SZ 0x10000000
-
-#define DEVICE_TYPE_RC 0x4
-#define QCOM_PCIE_2_1_0_MAX_SUPPLY 3
-#define QCOM_PCIE_2_1_0_MAX_CLOCKS 5
+#define QCOM_PCIE_2_1_0_MAX_SUPPLY 3
+#define QCOM_PCIE_2_1_0_MAX_CLOCKS 5
-#define QCOM_PCIE_CRC8_POLYNOMIAL (BIT(2) | BIT(1) | BIT(0))
+#define QCOM_PCIE_CRC8_POLYNOMIAL (BIT(2) | BIT(1) | BIT(0))
struct qcom_pcie_resources_2_1_0 {
struct clk_bulk_data clks[QCOM_PCIE_2_1_0_MAX_CLOCKS];
--
2.25.1
