On 10.02.2023 17:38, Krzysztof Kozlowski wrote:
> Add a minimal DTS for the new QRD8550 board - a mobile-like development
> board with SM8550. Serial, UFS and USB should be working.
>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
>
> ---
>
[...]
> +
> + vreg_l17b_2p5: ldo17 {
> + regulator-name = "vreg_l17b_2p5";
> + regulator-min-microvolt = <2504000>;
> + regulator-max-microvolt = <2504000>;
> + regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> + };
[...]
> + };
> +
> + vreg_l1g_1p2: ldo1 {
> + regulator-name = "vreg_l1g_1p2";
> + regulator-min-microvolt = <1200000>;
> + regulator-max-microvolt = <1200000>;
> + regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> + };
> +
> + vreg_l3g_1p2: ldo3 {
> + regulator-name = "vreg_l3g_1p2";
> + regulator-min-microvolt = <1200000>;
> + regulator-max-microvolt = <1200000>;
> + regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> + };
> + };
[...]
> +
> +&ufs_mem_hc {
> + reset-gpios = <&tlmm 210 GPIO_ACTIVE_LOW>;
> + vcc-supply = <&vreg_l17b_2p5>;
> + vcc-max-microamp = <1300000>;
> + vccq-supply = <&vreg_l1g_1p2>;
> + vccq-max-microamp = <1200000>;
> + vccq2-supply = <&vreg_l3g_1p2>;
None of these regulators have allowed-modes + allow-set-load,
I think you may want that.
With or without that:
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
> + vccq2-max-microamp = <100>;
> +
> + status = "okay";
> +};
> +
> +&ufs_mem_phy {
> + vdda-phy-supply = <&vreg_l1d_0p88>;
> + vdda-pll-supply = <&vreg_l3e_1p2>;
> +
> + status = "okay";
> +};
> +
> +&usb_1 {
> + status = "okay";
> +};
> +
> +&usb_1_dwc3 {
> + dr_mode = "peripheral";
> +};
> +
> +&usb_1_hsphy {
> + vdd-supply = <&vreg_l1e_0p88>;
> + vdda12-supply = <&vreg_l3e_1p2>;
> +
> + status = "okay";
> +};
> +
> +&usb_dp_qmpphy {
> + vdda-phy-supply = <&vreg_l3e_1p2>;
> + vdda-pll-supply = <&vreg_l3f_0p88>;
> +
> + status = "okay";
> +};
> +
> +&xo_board {
> + clock-frequency = <76800000>;
> +};
