Describe the properties used for shared boost configuration. Based on David Rhodes shared boost patches. Signed-off-by: Lucas Tanure <lucas.tanure@xxxxxxxxxxxxx> --- .../devicetree/bindings/sound/cirrus,cs35l41.yaml | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/sound/cirrus,cs35l41.yaml b/Documentation/devicetree/bindings/sound/cirrus,cs35l41.yaml index 18fb471aa891..f3c0a66f3474 100644 --- a/Documentation/devicetree/bindings/sound/cirrus,cs35l41.yaml +++ b/Documentation/devicetree/bindings/sound/cirrus,cs35l41.yaml @@ -85,11 +85,19 @@ properties: boost-cap-microfarad. External Boost must have GPIO1 as GPIO output. GPIO1 will be set high to enable boost voltage. + Shared boost allows two amplifiers to share a single boost circuit by + communicating on the MDSYNC bus. The passive amplifier does not control + the boost and receives data from the active amplifier. GPIO1 should be + configured for Sync when shared boost is used. Shared boost is not + compatible with External boost. Active amplifier requires + boost-peak-milliamp, boost-ind-nanohenry and boost-cap-microfarad. 0 = Internal Boost 1 = External Boost + 2 = Shared Boost Active + 3 = Shared Boost Passive $ref: /schemas/types.yaml#/definitions/uint32 minimum: 0 - maximum: 1 + maximum: 3 cirrus,gpio1-polarity-invert: description: -- 2.39.1