On Fri, Feb 03, 2023 at 10:18:07AM +0200, Abel Vesa wrote:
> Enable PCIe controllers and PHYs nodes on SM8550 MTP board.
>
> Co-developed-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
> ---
> +&pcie_1_phy_aux_clk {
> + clock-frequency = <1000>;
> +};
> +
> +&pcie0 {
> + wake-gpios = <&tlmm 96 GPIO_ACTIVE_HIGH>;
> + perst-gpios = <&tlmm 94 GPIO_ACTIVE_LOW>;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&pcie0_default_state>;
> +
> + status = "okay";
> +};
> +
> +&pcie0_phy {
> + vdda-phy-supply = <&vreg_l1e_0p88>;
> + vdda-pll-supply = <&vreg_l3e_1p2>;
Super nit: add newline for consistency.
> + status = "okay";
> +};
> +
> +&pcie1 {
> + wake-gpios = <&tlmm 99 GPIO_ACTIVE_HIGH>;
> + perst-gpios = <&tlmm 97 GPIO_ACTIVE_LOW>;
Neither controller needs the new enable gpio?
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&pcie1_default_state>;
> +
> + status = "okay";
> +};
> +
> +&pcie1_phy {
> + vdda-phy-supply = <&vreg_l3c_0p91>;
> + vdda-pll-supply = <&vreg_l3e_1p2>;
> + vdda-qref-supply = <&vreg_l1e_0p88>;
> +
> + status = "okay";
> +};
> +
> &pm8550_gpios {
> sdc2_card_det_n: sdc2-card-det-state {
> pins = "gpio12";
Johan
