On Mon, Nov 10, 2014 at 9:05 AM, Kevin Cernekee <cernekee@xxxxxxxxx> wrote: > On Mon, Nov 10, 2014 at 6:25 AM, Rob Herring <robh@xxxxxxxxxx> wrote: >> On Sun, Nov 9, 2014 at 2:55 AM, Kevin Cernekee <cernekee@xxxxxxxxx> wrote: >>> By default, bcm63xx_uart.c uses the standard 8250 device naming and >>> major/minor numbers. There are at least two situations where this could >>> be a problem: >>> >>> 1) Multiplatform kernels that need to support some chips that have 8250 >>> UARTs and other chips that have bcm63xx UARTs. >>> >>> 2) Some older chips like BCM7125 have a mix of both UART types. >>> >>> Add a new Kconfig option to tell the driver whether to register itself >>> as ttyS or ttyBCM. By default it will retain the existing "ttyS" >>> behavior to avoid surprises. >> >> While I understand the desire to have stable names, this is the >> opposite direction we want to go. Per platform tty names complicates >> having a generic userspace. It is not so bad since most ARM platforms >> use ttyS or ttyAMA, but just think what the kernel and userspace side >> would look like if every single platform did this. We can't change >> everything to ttyS because the other names are already an ABI. >> >> This can be solved with a udev rule to create sym links. > > Is it safe to register two console drivers named "ttyS" with the same > major/minor numbers? Maybe there is a trick to making them coexist? No, but I think you can do dynamic minor numbers. I seem to recall this coming up with the Samsung UARTs a while back. Rob > What I found is that everything worked fine on a system with > bcm63xx_uart hardware until I enabled the 8250 driver in .config. At > that point the drivers clashed and I had no serial output > post-bootconsole. It didn't even get to userland before it failed. > There are no DT entries mentioning 8250; the mere presence of the 8250 > driver killed my console. > > If this behavior is unexpected I can keep digging to find out what went wrong. > >> Or if you >> just need to know which dev node is h/w uart X, you can get that from >> sysfs. > > Right - I use busybox cttyhack in the init scripts to figure out the > console name, so the same rootfs image can be used for both ttyS0 and > ttyBCM0: > > # Put a shell on the serial port > ::respawn:/bin/cttyhack /bin/sh -l -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
