The binding references serial and rs485 schemas, so there is no need to
list their properties. Simplify a bit by removing unneeded entries.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
.../devicetree/bindings/serial/st,stm32-uart.yaml | 7 -------
1 file changed, 7 deletions(-)
diff --git a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
index 85876c668f6d..1df8ffe95fc6 100644
--- a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
+++ b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
@@ -35,8 +35,6 @@ properties:
description: enable hardware flow control (deprecated)
$ref: /schemas/types.yaml#/definitions/flag
- uart-has-rtscts: true
-
rx-tx-swap: true
dmas:
@@ -60,11 +58,6 @@ properties:
wakeup-source: true
- rs485-rts-delay: true
- rs485-rts-active-low: true
- linux,rs485-enabled-at-boot-time: true
- rs485-rx-during-tx: true
-
rx-threshold:
description:
If value is set to 1, RX FIFO threshold is disabled.
--
2.34.1
