Some regulators can run on different operating modes (opmodes). This allows systems to choose the most efficient opmode for each regulator. This patch builds on top of (291d761 regulator: Document binding for regulator suspend state for PM state) adding a regulator-initial-mode DT property to configure at startup the operating mode for regulators that support changing its mode during normal operation and a property regulator-mode to be used in the regulator-state-[mem/disk] nodes for regulators that supports changing its operating mode when the system enters in a suspend state. The set of possible modes that a regulator can operate depends on the hardware capabilities so a list of generic operating modes can't be provided. Instead, each hardware binding should define the list of valid operating modes for the regulators found on that device. Signed-off-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx> --- Changes in v6: - Remove assumptions about implementation details and don't overspecify. Suggested by Mark Brown. Changes in v5: None Changes in v4: None Changes in v3: - Rebased on top of regulator suspend voltage series Documentation/devicetree/bindings/regulator/regulator.txt | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 4e7ed76..abb26b5 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -30,6 +30,13 @@ Optional properties: - regulator-off-in-suspend: regulator should be off in suspend state. - regulator-suspend-microvolt: regulator should be set to this voltage in suspend. + - regulator-mode: operating mode in the given suspend state. + The set of possible operating modes depends on the capabilities of + every hardware so the valid modes are documented on each regulator + device tree binding document. +- regulator-initial-mode: initial operating mode. The set of possible operating + modes depends on the capabilities of every hardware so each device binding + documentation explains which values the regulator supports. Deprecated properties: - regulator-compatible: If a regulator chip contains multiple -- 2.1.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
