On 18/01/2023 05:44, Anand Moon wrote:
On Odroid c2 previously use gpio-hog to reset the usb hub, switch to used on-board usb hub reset to enable the usb hub and enable power to hub. Signed-off-by: Anand Moon <linux.amoon@xxxxxxxxx> --- v2 - drop the vendor name from compatible string. - move the hub node to USB controller node. - drop the usb_otg_pwr since it only liked to OTG port and link p5v0 to the vdd-supply. --- .../boot/dts/amlogic/meson-gxbb-odroidc2.dts | 26 ++++++++----------- 1 file changed, 11 insertions(+), 15 deletions(-) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts index 201596247fd9..01356437a077 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts @@ -250,21 +250,6 @@ eth_phy0: ethernet-phy@0 { }; };-&gpio_ao {- /* - * WARNING: The USB Hub on the Odroid-C2 needs a reset signal - * to be turned high in order to be detected by the USB Controller - * This signal should be handled by a USB specific power sequence - * in order to reset the Hub when USB bus is powered down. - */ - hog-0 { - gpio-hog; - gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>; - output-high; - line-name = "usb-hub-reset"; - }; -}; - &hdmi_tx { status = "okay"; pinctrl-0 = <&hdmi_hpd_pins>, <&hdmi_i2c_pins>; @@ -414,5 +399,16 @@ &usb0 { };&usb1 {+ dr_mode = "host"; + #address-cells = <1>; + #size-cells = <0>; status = "okay"; + + hub@1 { + /* Genesys Logic GL852G USB 2.0 hub */ + compatible = "usb5e3,610"; + reg = <1>; + vdd-supply = <&p5v0>; + reset-gpio = <&gpio_ao GPIOAO_4 GPIO_ACTIVE_LOW>; + }; };
Reviewed-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
