On 29/12/2022 21:02, Stephan Gerhold wrote:
On Thu, Dec 29, 2022 at 08:45:15PM +0100, Stephan Gerhold wrote:
On Thu, Dec 29, 2022 at 06:34:10PM +0000, Bryan O'Donoghue wrote:
Downstream has a flag called qcom,dp-manual-pullup which informs the
downstream driver if it should toggle ULPI_MISC_A_VBUSVLDEXTSEL and
ULPI_MISC_A_VBUSVLDEXT.
Downstream states:
"qcom,dp-manual-pullup: If present, vbus is not routed to USB
controller/phy and controller driver therefore enables pull-up
explicitly before starting controller using usbcmd run/stop bit."
Working with a system that has both an external Type-C port controller and
an internal USB Hub results in a situation where VBUS is not connected to
the SoC.
In this case we still need to set the DP pullup.
This patch enables and disables the DP pullup on PHY power_on and power_off
respectively if the DT has declared the bool "qcom,enable-vbus-pullup"
effectively replicating the downstream logic to the same effect.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
[...]
An alternative that I've occasionally used for early bring-up is to
simply use a dummy extcon driver [1] that permanently reports active
VBUS. The end result is the same. While it's clearly a hack perhaps this
makes it a bit more clear that ideally you really should try to assign
an extcon device, to avoid keeping the USB controller and PHY on
permanently.
BTW another nice trick that should work in all almost all cases is to
use the state of the PMIC USB_IN pin as VBUS detection. All battery-
powered devices I have seen route the USB VBUS to PM8916 USB_IN. And
even many boards like DB410c seem to do that or at least permanently
supply 5V there. In all these cases the &pm8916_usbin extcon will
report a VBUS state that should make USB work.
Have you tried using that on your MSM8939 board with the Type-C setup?
&pm8916_usbin {
status = "okay";
};
&usb {
status = "okay";
usb-role-switch;
extcon = <&pm8916_usbin>;
};
&usb_hs_phy {
extcon = <&pm8916_usbin>;
};
Stephan
I checked USBIN before my last email reply.
Its possible its connected but its not there on the 8939 schematic I have.
---
bod
