On Tue, Dec 13, 2022 at 05:24:32PM +0900, Kunihiko Hayashi wrote: > This series introduces dt-bindings documents for miscellaneous register > blocks implemented in Socionext UniPhier SoCs. > > These are previously defined in the devicetree and used in the examples > of subnodes' dt-bindings, however, not documented. > > These include two types of the blocks > > * independent block including miscellaneous registers and functions for > the whole SoC (system controller and SoC-glue logic) > > * sideband logic including control registers in the component (others) > > And prior to adding these dt-bindings, fix examples in the existing > dt-bindings. > > This series is part of the previous series shown below: > https://lore.kernel.org/linux-arm-kernel/20221107103410.3443-2-hayashi.kunihiko@xxxxxxxxxxxxx > > Changes since v2: > - Drop redundant nodes in examples (clock, reset, soc-glue-debug) > - Drop parent node in examples > - Add more properties to examples for pinctrl > - Add a patch for regulator change > - Use consistent quotes > - Drop unit address patterns of patternProperties > - Mandatory unit address pattern for efuse (soc-glue-debug) > - Fix additionalProperties (ahci-glue) > > Changes since v1: > - Fix examples in the existing dt-bindings (Add PATCH 1-7) > - Add dt-bindings for SoC-glue logic debug part (Add PATCH 10) > - Drop generic and ld6b compatible strings > - Change "usb-controller" node in soc-glue to "usb-hub" > - Change "usb-controller" node in USB glue layer example to "usb" > - Add negation of child properties by compatible string > > Kunihiko Hayashi (17): > dt-bindings: clock: Fix node descriptions in uniphier-clock example > dt-bindings: reset: Fix node descriptions in uniphier-reset example > dt-bindings: pinctrl: Fix node descriptions in uniphier-pinctrl > example > dt-bindings: regulator: Fix node descriptions in uniphier-regulator > example > dt-bindings: watchdog: Fix node descriptions in uniphier-wdt example > dt-bindings: thermal: Fix node descriptions in uniphier-thermal > example > dt-bindings: phy: Fix node descriptions in uniphier-phy example > dt-bindings: nvmem: Fix node descriptions in uniphier-efuse example > dt-bindings: soc: socionext: Add UniPhier system controller > dt-bindings: soc: socionext: Add UniPhier SoC-glue logic > dt-bindings: soc: socionext: Add UniPhier SoC-glue logic debug part > dt-bindings: soc: socionext: Add UniPhier peripheral block > dt-bindings: soc: socionext: Add UniPhier media I/O block > dt-bindings: soc: socionext: Add UniPhier SD interface block > dt-bindings: soc: socionext: Add UniPhier ADAMV block > dt-bindings: soc: socionext: Add UniPhier DWC3 USB glue layer > dt-bindings: soc: socionext: Add UniPhier AHCI glue layer You sent this To me, so I'm assuming you want me to apply it? Otherwise, it can go via the Socionext tree. Let me know and I can fix up Krzysztof's comments and apply the series. Rob
