Use the correct compatible 'nxp,se97b' as it is an SE97BTP chip.
While at it, fix the node name according to device tree spec
recommendations. The EEPROM is a separate node anyway.
Signed-off-by: Alexander Stein <alexander.stein@xxxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
index 88d89cd46c74a..b4466a26d838a 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi
@@ -87,8 +87,8 @@ &i2c1 {
sda-gpios = <&gpio5 15 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
status = "okay";
- sensor0: temperature-sensor-eeprom@1b {
- compatible = "nxp,se97", "jedec,jc-42.4-temp";
+ sensor0: temperature-sensor@1b {
+ compatible = "nxp,se97b", "jedec,jc-42.4-temp";
reg = <0x1b>;
};
--
2.34.1
