Re: [PATCH v3 3/3] mmc: xenon: Fix 2G limitation on AC5 SoC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 12/12/22 13:34, Vadym Kochan wrote:
> Hi Adrian,
> 
> On Mon, 12 Dec 2022 10:42:36 +0200, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
>> On 9/12/22 15:27, Vadym Kochan wrote:
>>> On Fri, 9 Dec 2022 14:13:06 +0200, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
>>>> On 9/12/22 14:10, Vadym Kochan wrote:
>>>>> Hi Adrian,
>>>>>
>>>>> On Fri, 9 Dec 2022 13:53:58 +0200, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
>>>>>> On 9/12/22 13:39, Vadym Kochan wrote:
>>>>>>> Hi Adrian,
>>>>>>>
>>>>>>> On Fri, 9 Dec 2022 09:23:05 +0200, Adrian Hunter <adrian.hunter@xxxxxxxxx> wrote:
>>>>>>>> On 5/12/22 12:59, Vadym Kochan wrote:
>>>>>>>>> There is a limitation on AC5 SoC that mmc controller
>>>>>>>>> can't have DMA access over 2G memory, so use SDMA with
>>>>>>>>> a bounce buffer. Swiotlb can't help because on arm64 arch
>>>>>>>>> it reserves memblock's at the end of the memory.
>>>>>>>>>
>>>>>>>>> Additionally set mask to 34 bit since on AC5 SoC RAM starts
>>>>>>>>> at 0x2_00000000.
>>>>>>>>
>>>>>>>> Can you explain more about how a 34-bit DMA mask works when
>>>>>>>> SDMA only supports 32-bit addresses?
>>>>>>>>
>>>>>>>
>>>>>>> So, after I set
>>>>>>>
>>>>>>>>> +		host->flags &= ~SDHCI_USE_64_BIT_DMA;
>>>>>>>
>>>>>>> then sdhc core sets mask to 32 bit, but then dma_map fails to map
>>>>>>> bounce buffer because the base address is higher than 32bit - 0x2_00000000,
>>>>>>> and 34bit mask fixed it.
>>>>>>
>>>>>> What happens if the bounce buffer gets mapped in the range
>>>>>> 0x1_00000000 to 0x1_ffffffff ?
>>>>>>
>>>>>
>>>>> From my understanding, on the AC5 SoC RAM starts at 0x2_00000000 so the bounce
>>>>> buffer can be mapped in the range 0x2_00000000..0x2_ffffffff
>>>>
>>>> Right but I guess I meant what about 0x3_00000000..0x3_ffffffff ?
>>>> Isn't that also in DMA_BIT_MASK(34)
>>>
>>> Yes, you are right.
>>
>> So it would fail in that case?  Is it possible to use devicetree
>> reserved memory or some such, to set aside 64k for the bounce
>> buffer DMA mapping?
>>
> 
> The main restriction is that only lower 2GB can be used for DMA.
> 
> I already did send solution based on reserved memory, I can send it again in context of this series.
> Also what about the solution which Linus suggested ?
> 
> [cut]
> 
> Let's just create a new quirk:
> 
> SDHCI_QUIRK_31BIT_DMA_ROOF
> 
> Define the semantics such that this will allow DMA for buffers that are below
> the 31st bit, but does not have the semantics to limit scatter-gather buffers to
> be 32-bit aligned.
> 
> [/cut]

Wouldn't that need to be done after DMA mapping?

In the SDMA case, the bounce buffer would need to be
checked only once and if wrong then it would be
PIO-only for all requests.  You probably don't need
need a quirk for that since the check could be done
at probe time.

In the ADMA case the ADMA table would have to be
checked also.  And then after every dma_map_sg().

Seems a bit messy?

> 
> Thanks,
> 
>>>
>>>>
>>>>>
>>>>>>>
>>>>>>>>>
>>>>>>>>> Co-developed-by: Elad Nachman <enachman@xxxxxxxxxxx>
>>>>>>>>> Signed-off-by: Elad Nachman <enachman@xxxxxxxxxxx>
>>>>>>>>> Signed-off-by: Vadym Kochan <vadym.kochan@xxxxxxxxxxx>
>>>>>>>>> ---
>>>>>>>>>  drivers/mmc/host/sdhci-xenon.c | 38 ++++++++++++++++++++++++++++++++++
>>>>>>>>>  drivers/mmc/host/sdhci-xenon.h |  3 ++-
>>>>>>>>>  2 files changed, 40 insertions(+), 1 deletion(-)
>>>>>>>>>
>>>>>>>>> diff --git a/drivers/mmc/host/sdhci-xenon.c b/drivers/mmc/host/sdhci-xenon.c
>>>>>>>>> index 08e838400b52..5f3db0425674 100644
>>>>>>>>> --- a/drivers/mmc/host/sdhci-xenon.c
>>>>>>>>> +++ b/drivers/mmc/host/sdhci-xenon.c
>>>>>>>>> @@ -13,7 +13,9 @@
>>>>>>>>>  
>>>>>>>>>  #include <linux/acpi.h>
>>>>>>>>>  #include <linux/delay.h>
>>>>>>>>> +#include <linux/dma-mapping.h>
>>>>>>>>>  #include <linux/ktime.h>
>>>>>>>>> +#include <linux/mm.h>
>>>>>>>>>  #include <linux/module.h>
>>>>>>>>>  #include <linux/of.h>
>>>>>>>>>  #include <linux/pm.h>
>>>>>>>>> @@ -253,6 +255,22 @@ static unsigned int xenon_get_max_clock(struct sdhci_host *host)
>>>>>>>>>  		return pltfm_host->clock;
>>>>>>>>>  }
>>>>>>>>>  
>>>>>>>>> +static int xenon_set_dma_mask(struct sdhci_host *host)
>>>>>>>>> +{
>>>>>>>>> +	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
>>>>>>>>> +	struct xenon_priv *priv = sdhci_pltfm_priv(pltfm_host);
>>>>>>>>> +	struct mmc_host *mmc = host->mmc;
>>>>>>>>> +	struct device *dev = mmc_dev(mmc);
>>>>>>>>> +
>>>>>>>>> +	if (priv->hw_version == XENON_AC5) {
>>>>>>>>> +		host->flags &= ~SDHCI_USE_64_BIT_DMA;
>>>>>>>>> +
>>>>>>>>> +		return dma_set_mask_and_coherent(dev, DMA_BIT_MASK(34));
>>>>>>>>> +	}
>>>>>>>>> +
>>>>>>>>> +	return sdhci_set_dma_mask(host);
>>>>>>>>> +}
>>>>>>>>> +
>>>>>>>>>  static const struct sdhci_ops sdhci_xenon_ops = {
>>>>>>>>>  	.voltage_switch		= xenon_voltage_switch,
>>>>>>>>>  	.set_clock		= sdhci_set_clock,
>>>>>>>>> @@ -261,6 +279,7 @@ static const struct sdhci_ops sdhci_xenon_ops = {
>>>>>>>>>  	.reset			= xenon_reset,
>>>>>>>>>  	.set_uhs_signaling	= xenon_set_uhs_signaling,
>>>>>>>>>  	.get_max_clock		= xenon_get_max_clock,
>>>>>>>>> +	.set_dma_mask		= xenon_set_dma_mask,
>>>>>>>>>  };
>>>>>>>>>  
>>>>>>>>>  static const struct sdhci_pltfm_data sdhci_xenon_pdata = {
>>>>>>>>> @@ -486,6 +505,18 @@ static void xenon_sdhc_unprepare(struct sdhci_host *host)
>>>>>>>>>  	xenon_disable_sdhc(host, sdhc_id);
>>>>>>>>>  }
>>>>>>>>>  
>>>>>>>>> +static int xenon_ac5_probe(struct sdhci_host *host)
>>>>>>>>> +{
>>>>>>>>> +	struct sysinfo si;
>>>>>>>>> +
>>>>>>>>> +	si_meminfo(&si);
>>>>>>>>> +
>>>>>>>>> +	if ((si.totalram * si.mem_unit) > SZ_2G)
>>>>>>>>> +		host->quirks |= SDHCI_QUIRK_BROKEN_ADMA;
>>>>>>>>> +
>>>>>>>>> +	return 0;
>>>>>>>>> +}
>>>>>>>>> +
>>>>>>>>>  static int xenon_probe(struct platform_device *pdev)
>>>>>>>>>  {
>>>>>>>>>  	struct sdhci_pltfm_host *pltfm_host;
>>>>>>>>> @@ -533,6 +564,12 @@ static int xenon_probe(struct platform_device *pdev)
>>>>>>>>>  		}
>>>>>>>>>  	}
>>>>>>>>>  
>>>>>>>>> +	if (priv->hw_version == XENON_AC5) {
>>>>>>>>> +		err = xenon_ac5_probe(host);
>>>>>>>>> +		if (err)
>>>>>>>>> +			goto err_clk_axi;
>>>>>>>>> +	}
>>>>>>>>> +
>>>>>>>>>  	err = mmc_of_parse(host->mmc);
>>>>>>>>>  	if (err)
>>>>>>>>>  		goto err_clk_axi;
>>>>>>>>> @@ -682,6 +719,7 @@ static const struct of_device_id sdhci_xenon_dt_ids[] = {
>>>>>>>>>  	{ .compatible = "marvell,armada-ap807-sdhci", .data = (void *)XENON_AP807},
>>>>>>>>>  	{ .compatible = "marvell,armada-cp110-sdhci", .data =  (void *)XENON_CP110},
>>>>>>>>>  	{ .compatible = "marvell,armada-3700-sdhci", .data =  (void *)XENON_A3700},
>>>>>>>>> +	{ .compatible = "marvell,ac5-sdhci", .data = (void *)XENON_AC5},
>>>>>>>>>  	{}
>>>>>>>>>  };
>>>>>>>>>  MODULE_DEVICE_TABLE(of, sdhci_xenon_dt_ids);
>>>>>>>>> diff --git a/drivers/mmc/host/sdhci-xenon.h b/drivers/mmc/host/sdhci-xenon.h
>>>>>>>>> index 3e9c6c908a79..0460d97aad26 100644
>>>>>>>>> --- a/drivers/mmc/host/sdhci-xenon.h
>>>>>>>>> +++ b/drivers/mmc/host/sdhci-xenon.h
>>>>>>>>> @@ -57,7 +57,8 @@ enum xenon_variant {
>>>>>>>>>  	XENON_A3700,
>>>>>>>>>  	XENON_AP806,
>>>>>>>>>  	XENON_AP807,
>>>>>>>>> -	XENON_CP110
>>>>>>>>> +	XENON_CP110,
>>>>>>>>> +	XENON_AC5
>>>>>>>>>  };
>>>>>>>>>  
>>>>>>>>>  struct xenon_priv {
>>>>>>>>
>>>>>>>
>>>>>>> Regards,
>>>>>>
>>>>
>>




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux