On 9.12.2022 18:12, Douglas Anderson wrote:
> On at least one board (pazquel360) the reset line for the touchscreen
> was scoped and found to take almost 2 ms to fall when we drove it
> low. This wasn't great because the Linux driver for the touchscreen
> (the elants_i2c driver) thinks it can do a 500 us reset pulse. If we
> bump the drive strength to 8 mA then the reset line went down in ~421
> us.
>
> NOTE: we could apply this fix just for pazquel360, but:
> * Probably other trogdor devices have similar timings and it's just
> that nobody has noticed it before.
> * There are other trogdor boards using the same elan driver that tries
> to do 500 us reset pulses.
> * Bumping the drive strength to 8mA across the board won't hurt. This
> isn't a high speed signal or anything.
>
> Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
>
> (no changes since v1)
>
> arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi | 10 +++++++++-
> 1 file changed, 9 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
> index f1defb94d670..ff1c7aa6a722 100644
> --- a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
> @@ -1376,7 +1376,15 @@ ts_reset_l: ts-reset-l-state {
> pins = "gpio8";
> function = "gpio";
> bias-disable;
> - drive-strength = <2>;
> +
> + /*
> + * The reset GPIO to the touchscreen takes almost 2ms to drop
> + * at the default drive strength. When we bump it up to 8mA it
> + * falls in under 500us. We want this to be fast since the Elan
> + * datasheet (and any drivers written based on it) talk about using
> + * a 500 us reset pulse.
> + */
> + drive-strength = <8>;
> };
>
> sdc1_on: sdc1-on-state {
