On Thu, Oct 30, 2014 at 6:55 AM, Thierry Reding
<thierry.reding@xxxxxxxxx> wrote:
> On Wed, Oct 29, 2014 at 09:37:14AM -0700, Andrew Bresticker wrote:
>> On Wed, Oct 29, 2014 at 2:43 AM, Thierry Reding
>> <thierry.reding@xxxxxxxxx> wrote:
>> > On Tue, Oct 28, 2014 at 03:27:50PM -0700, Andrew Bresticker wrote:
>> > [...]
>> >> diff --git a/Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-xusb-padctl.txt b/Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-xusb-padctl.txt
>> > [...]
>> >> +Optional properties:
>> >> +-------------------
>> >> +- vbus-{0,1,2}-supply: VBUS regulator for the corresponding UTMI pad.
>> >> +- vddio-hsic-supply: VDDIO regulator for the HSIC pads.
>> >> +- nvidia,usb3-port-{0,1}-lane: PCIe/SATA lane to which the corresponding USB3
>> >> + port is mapped. See <dt-bindings/pinctrl/pinctrl-tegra-xusb.h> for the list
>> >> + of valid values.
>> >
>> > I dislike how we now need to provide a list of all pins in the header
>> > file, where previously we used strings for this. This could become very
>> > ugly if the set of pins changes in future generations of this IP block.
>> >
>> > Could we instead derive this from the pinmux nodes? For example you have
>> > this in the example below:
>> >
>> > usb3p0 {
>> > nvidia,lanes = "pcie-0";
>> > ...
>> > };
>> >
>> > Perhaps what we need is to either key off the node name or add another
>> > property, such as:
>> >
>> > nvidia,usb3-port = <0>;
>> >
>> > This would match the nvidia,usb2-port property that you've added below.
>>
>> That is actually how I described the USB3 port to SS lane mapping
>> originally, but in review of an earlier version of this series,
>> Stephen suggested that I make it a separate, not pinconfig property
>> since it wasn't a value written directly to the hardware. I'm fine
>> with changing it back as the pinconfig property makes more sense to me
>> as well.
>
> Hmm... I had considered it a mux option of the specific lane. If the
> function is usb3, it'd still need to be muxed to one of the ports. So
> it's additional information associated with the usb3 function.
>
> I did look through the driver changes and can't really make out which
> part of the code actually performs this assignment. Can you point me to
> it?
There's not really an assignment. The property is used to map between
a lane (e.g. PCIe-0 or SATA) and the USB3.0 port it's mapped to. For
an example of where it's used, take a look at usb3_phy_power_on().
There are certain per-lane registers which need to be programmed in
addition to the per-USB3.0 port pad registers. This mapping is used
to determine which lane needs to be programmed.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
