On Thu, Dec 01, 2022 at 05:02:41PM +0800, Yanhong Wang wrote:
> Add JH7110 ethernet device node to support gmac driver for the JH7110
> RISC-V SoC.
>
> Signed-off-by: Yanhong Wang <yanhong.wang@xxxxxxxxxxxxxxxx>
> ---
> arch/riscv/boot/dts/starfive/jh7110.dtsi | 80 ++++++++++++++++++++++++
> 1 file changed, 80 insertions(+)
>
> diff --git a/arch/riscv/boot/dts/starfive/jh7110.dtsi b/arch/riscv/boot/dts/starfive/jh7110.dtsi
> index c22e8f1d2640..97ed5418d91f 100644
> --- a/arch/riscv/boot/dts/starfive/jh7110.dtsi
> +++ b/arch/riscv/boot/dts/starfive/jh7110.dtsi
> @@ -433,5 +433,85 @@
> reg-shift = <2>;
> status = "disabled";
> };
> +
> + stmmac_axi_setup: stmmac-axi-config {
> + snps,wr_osr_lmt = <4>;
> + snps,rd_osr_lmt = <4>;
> + snps,blen = <256 128 64 32 0 0 0>;
> + };
> +
> + gmac0: ethernet@16030000 {
> + compatible = "starfive,dwmac", "snps,dwmac-5.20";
> + reg = <0x0 0x16030000 0x0 0x10000>;
> + clocks = <&aoncrg JH7110_AONCLK_GMAC0_AXI>,
> + <&aoncrg JH7110_AONCLK_GMAC0_AHB>,
> + <&syscrg JH7110_SYSCLK_GMAC0_PTP>,
> + <&aoncrg JH7110_AONCLK_GMAC0_TX>,
> + <&syscrg JH7110_SYSCLK_GMAC0_GTXC>,
> + <&syscrg JH7110_SYSCLK_GMAC0_GTXCLK>;
> + clock-names = "stmmaceth",
> + "pclk",
> + "ptp_ref",
> + "tx",
> + "gtxc",
> + "gtx";
Can you sort this into fewer lines please?
> + resets = <&aoncrg JH7110_AONRST_GMAC0_AXI>,
> + <&aoncrg JH7110_AONRST_GMAC0_AHB>;
> + reset-names = "stmmaceth", "ahb";
> + interrupts = <7>, <6>, <5> ;
Please also remove the space before the ;
> + interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
The answer is probably "the dw driver needs this" but my OCD really
hates "macirq" vs "eth_wake_irq"..
> + phy-mode = "rgmii-id";
> + snps,multicast-filter-bins = <64>;
> + snps,perfect-filter-entries = <8>;
> + rx-fifo-depth = <2048>;
> + tx-fifo-depth = <2048>;
> + snps,fixed-burst;
> + snps,no-pbl-x8;
> + snps,force_thresh_dma_mode;
> + snps,axi-config = <&stmmac_axi_setup>;
> + snps,tso;
> + snps,en-tx-lpi-clockgating;
> + snps,lpi_en;
> + snps,txpbl = <16>;
> + snps,rxpbl = <16>;
> + status = "disabled";
> + };
> +
> + gmac1: ethernet@16040000 {
> + compatible = "starfive,dwmac", "snps,dwmac-5.20";
> + reg = <0x0 0x16040000 0x0 0x10000>;
> + clocks = <&syscrg JH7110_SYSCLK_GMAC1_AXI>,
> + <&syscrg JH7110_SYSCLK_GMAC1_AHB>,
> + <&syscrg JH7110_SYSCLK_GMAC1_PTP>,
> + <&syscrg JH7110_SYSCLK_GMAC1_TX>,
> + <&syscrg JH7110_SYSCLK_GMAC1_GTXC>,
> + <&syscrg JH7110_SYSCLK_GMAC1_GTXCLK>;
> + clock-names = "stmmaceth",
> + "pclk",
> + "ptp_ref",
> + "tx",
> + "gtxc",
> + "gtx";
> + resets = <&syscrg JH7110_SYSRST_GMAC1_AXI>,
> + <&syscrg JH7110_SYSRST_GMAC1_AHB>;
> + reset-names = "stmmaceth", "ahb";
> + interrupts = <78>, <77>, <76> ;
Same comments for this node.
> + interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
> + phy-mode = "rgmii-id";
> + snps,multicast-filter-bins = <64>;
> + snps,perfect-filter-entries = <8>;
> + rx-fifo-depth = <2048>;
> + tx-fifo-depth = <2048>;
> + snps,fixed-burst;
> + snps,no-pbl-x8;
> + snps,force_thresh_dma_mode;
> + snps,axi-config = <&stmmac_axi_setup>;
> + snps,tso;
> + snps,en-tx-lpi-clockgating;
> + snps,lpi_en;
> + snps,txpbl = <16>;
> + snps,rxpbl = <16>;
> + status = "disabled";
> + };
> };
> };
> --
> 2.17.1
>
