Hi Arnd, Per Linus, shall we hold this driver until the GIC submission complete ? Or we will send the version without access GIC to read status in case the GPIO is configured IRQ ? +static int xgene_gpio_sb_get(struct gpio_chip *gc, u32 gpio) +{ + struct of_mm_gpio_chip *mm_gc = to_of_mm_gpio_chip(gc); + struct xgene_gpio_sb *chip = to_xgene_gpio_sb(mm_gc); + u32 data; + + data = ioread32(mm_gc->regs + MPA_GPIO_IN_ADDR); + + return (data & GPIO_MASK(gpio)) ? 1 : 0; +} Regards, Y On Wed, Oct 29, 2014 at 5:24 PM, Arnd Bergmann <arnd@xxxxxxxx> wrote: > On Wednesday 29 October 2014 10:52:47 Linus Walleij wrote: >> On Fri, Oct 24, 2014 at 3:46 PM, Arnd Bergmann <arnd@xxxxxxxx> wrote: >> > On Friday 24 October 2014 14:14:43 Linus Walleij wrote: >> > See the discussion I had on this. Yes, each line is connected to a >> > GIC SPI interrupt by itself. I've discussed this with Marc Zyngier >> > and Thomas Gleixner at the conference last week, and we concluded >> > that we will need a new generic interface to get data out of the >> > parent interrupt controller in a proper way. The current implementation >> > just maps the GIC registers and reads them directly, which of course >> > is not a proper way to do it. >> >> Hmmmmmm. OK shall we hold this driver until the infrastructure >> issues are resolved? > > Y could send a first version that does not support the IRQ lines > if he wants to speed up the process. > >> The following is a recurring pattern among GPIO controllers: >> the GPIO controller can go offline (asycnhcronous) and while it >> is offline a secondary logic triggers an IRQ that wakes the system >> up, however the GPIO logic cannot really "see" that IRQ since >> it was sleeping when it arrived. >> >> Thus a latent IRQ is pending in the wakeup logic. This concept >> exists in drivers/pinctrl/nomadik/pinctrl-nomadik.c and I strongly >> prefer to call these "latent irqs" as it's a clear unambigous >> terminology. >> >> So is this a case of latent IRQs pending in the GIC? > > I think this case is different, from what I understand, the GPIO > controller cannot implement gpio_chip->get() for any line that > is connected to the GIC, and it has to ask the GIC instead. > This seems independent of the online/offline state of the controller. > > Arnd -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html