On 18/11/2022 15:03, Krzysztof Kozlowski wrote:
On 18/11/2022 14:30, neil.armstrong@xxxxxxxxxx wrote:
On 18/11/2022 11:45, Krzysztof Kozlowski wrote:
On 17/11/2022 10:47, Neil Armstrong wrote:
+
+properties:
+ compatible:
+ const: qcom,mpss-dsm-mem
Why do we need dedicated binding and compatible for it instead of using
memory-region phandle in the device?
So like rmtfs, this memory zone is shared between APPS and the MPSS subsystem.
Like rmtfs it makes no sense to link it to the MPSS PAS, since it's only a launcher,
it doesn't represent the MPSS subsystem.
This also does not represent a device. Memory region is not a device, so
this is as well not correct representation of hardware.
I never used the term device so far, but a shared memory region with a platform
specific process to share the region between subsystems.
Yes, but you create a device in patch #2 for this binding.
Implementation details are out of scope here.
In the PAS startup process, the resources are released from APPS once the MPSS subsystem
is running, which is not the case with the MPSS DSM where it must be shared during the whole
lifetime of the system.
I don't think that PAS releases the region. I checked the
qcom_q6v5_pas.c and there is only ioremap. The device stays loaded thus
the memory stays mapped.
Yes PAS does release the firmware region when the firmware is started,
qcom_scm_pas_metadata_release() does that.
Indeed, I see it now.
We have already three of such "memory region devices" and we keep
growing it. It's not scalable.
If we want to properly describe this, we must then represent the MPSS subsystem
and associate this memory region.
I don't see why. None of devices in your DTS reference this memory
region, so it is purely to keep it mapped for Modem, right? In such case
I still do not get why PAS/PIL, who starts and stops the remote
processor, could not prepare the memory and share it with modem.
OK you've got a point, but this is still an implementation detail.
I got some more background about why this memory zone appeared, before it
was including in the modem reserved-memories, but for flexibility reasons
this is now in the hands of the APPS runtime (linux) to setup this memory
zone and share it to the MPSS subsystem.
So the only requirement for the PAS is to make sure this zone is shared
before starting the startup process, not to actually do the share setup.
The zone will need to be shared whatever the PAS state is (probe, startup, remove, ...).
The point is that this memory region is nothing special and does not
deserve its own compatible. We keep adding here compatibles to fulfill
some Linux implementation specifics, don't we?
Yes this memory region is now special since it has to be shared explicitly.
Best regards,
Krzysztof
Thanks,
Neil
