From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx> This Series adds some Nodes to mt7986 devicetree and the BananaPi R3 This version is rebased on Matthias' DTS64 next Branch from 2022/11/11. i included sams series for mt7986 DTS with small changes https://patchwork.kernel.org/project/linux-mediatek/cover/20220427124741.18245-> 6.2 will support dtso extension for dt overlays: "kbuild: Allow DTB overlays to built from .dtso named source files" https://git.kernel.org/pub/scm/linux/kernel/git/robh/linux.git/commit/?h=dt/next&id=363547d2191cbc32ca954ba75d72908712398ff2 There is some discussion about inclusion of dt-overlays and if it is better to support mmc also by these: https://patchwork.kernel.org/comment/25092116/ https://patchwork.kernel.org/comment/25085681/ i had run full dtbs-check but i end up with some strange warnings in ethernet-node that should not come up as phy-handle and sfp/managed properties are already defined. phy-handle made optional https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/Documen> property sfp/managed (which is included for mac subnode in yaml above): https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/Documen> changes: v5: - changed usb ranges/reg/unit-adress - added reviewd-by's except usb-part due to changes v4: - dropped RFC prefix - rebase on matthias' mtk dts-next (for 6.2) branch - added author information to overlays - fixed sfp binding error - added fix for moving wed_pcie node - readded missing compatible patches v3: - changed mmc pull-ups - added patch for board binding (sent separately before) - added pcie node in mt7986 (not yet again in r3) - added dt overlays Frank Wunderlich (7): arm64: dts: mt7986: move wed_pcie node dt-bindings: phy: mediatek,tphy: add support for mt7986 dt-bindings: usb: mtk-xhci: add support for mt7986 dt-bindings: PCI: mediatek-gen3: add SoC based clock config dt-bindings: PCI: mediatek-gen3: add support for mt7986 arm64: dts: mt7986: add Bananapi R3 arm64: dts: mt7986: add BPI-R3 nand/nor overlays Sam Shih (4): arm64: dts: mt7986: add spi related device nodes arm64: dts: mt7986: add usb related device nodes arm64: dts: mt7986: add mmc related device nodes arm64: dts: mt7986: add pcie related device nodes .../bindings/pci/mediatek-pcie-gen3.yaml | 64 ++- .../bindings/phy/mediatek,tphy.yaml | 1 + .../bindings/usb/mediatek,mtk-xhci.yaml | 1 + arch/arm64/boot/dts/mediatek/Makefile | 4 + .../mediatek/mt7986a-bananapi-bpi-r3-emmc.dts | 31 ++ .../mediatek/mt7986a-bananapi-bpi-r3-nand.dts | 55 +++ .../mediatek/mt7986a-bananapi-bpi-r3-nor.dts | 69 +++ .../mediatek/mt7986a-bananapi-bpi-r3-sd.dts | 25 + .../dts/mediatek/mt7986a-bananapi-bpi-r3.dtsi | 458 ++++++++++++++++++ arch/arm64/boot/dts/mediatek/mt7986a-rfb.dts | 166 +++++++ arch/arm64/boot/dts/mediatek/mt7986a.dtsi | 162 ++++++- arch/arm64/boot/dts/mediatek/mt7986b-rfb.dts | 63 +++ 12 files changed, 1081 insertions(+), 18 deletions(-) create mode 100644 arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-emmc.dts create mode 100644 arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nand.dts create mode 100644 arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nor.dts create mode 100644 arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-sd.dts create mode 100644 arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3.dtsi -- 2.34.1
