Wire up necessary supplies to USB PHYs to enable USB3 on Sagami and
remove all the limit-to-USB2 properties.
Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
---
.../boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi b/arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi
index f118caab3d42..4dcaeb7f9bc8 100644
--- a/arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi
@@ -597,25 +597,25 @@ ts_int_default: ts-int-default-state {
&ufs_mem_hc { status = "disabled"; };
&ufs_mem_phy { status = "disabled"; };
-/* TODO: Make USB3 work (perhaps needs regulators for higher-current operation?) */
&usb_1 {
status = "okay";
-
- qcom,select-utmi-as-pipe-clk;
};
&usb_1_dwc3 {
dr_mode = "peripheral";
-
- maximum-speed = "high-speed";
- phys = <&usb_1_hsphy>;
- phy-names = "usb2-phy";
};
&usb_1_hsphy {
status = "okay";
+
+ vdda-pll-supply = <&pm8350_l5>;
+ vdda18-supply = <&pm8350c_l1>;
+ vdda33-supply = <&pm8350_l2>;
};
&usb_1_qmpphy {
status = "okay";
+
+ vdda-phy-supply = <&pm8350_l6>;
+ vdda-pll-supply = <&pm8350_l1>;
};
--
2.38.1
