This adds the devicetree binding documentation for the LTC2941 and LTC2943
driver. These are I2C connected battery gas gauge ICs.
Signed-off-by: Mike Looijmans <mike.looijmans@xxxxxxxx>
---
.../devicetree/bindings/power/ltc2941.txt | 27 ++++++++++++++++++++
1 file changed, 27 insertions(+)
create mode 100644 Documentation/devicetree/bindings/power/ltc2941.txt
diff --git a/Documentation/devicetree/bindings/power/ltc2941.txt b/Documentation/devicetree/bindings/power/ltc2941.txt
new file mode 100644
index 0000000..ea42ae1
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/ltc2941.txt
@@ -0,0 +1,27 @@
+binding for LTC2941 and LTC2943 battery gauges
+
+Both the LTC2941 and LTC2943 measure battery capacity.
+The LTC2943 is compatible with the LTC2941, it adds voltage and
+temperature monitoring, and uses a slightly different conversion
+formula for the charge counter.
+
+Required properties:
+- compatible: Should contain "ltc2941" or "ltc2943" which also indicates the
+ type of I2C chip attached.
+- reg: The 7-bit I2C address.
+- lltc,resistor-sense: The sense resistor value in milli-ohms. Can be a 32-bit
+ negative value when the battery has been connected to the wrong end of the
+ resistor.
+- lltc,prescaler-exponent: The prescaler exponent as explained in the datasheet.
+ This determines the range and accuracy of the gauge. The value is programmed
+ into the chip only if it differs from the current setting. The setting is
+ lost when the battery is disconnected.
+
+Example from the Topic Miami Florida board:
+
+ fuelgauge: ltc2943@64 {
+ compatible = "ltc2943";
+ reg = <0x64>;
+ lltc,resistor-sense = <15>;
+ lltc,prescaler-exponent = <5>; /* 2^(2*5) = 1024 */
+ };
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
